+ Reply to Thread
Page 5 of 5 FirstFirst ... 3 4 5
Results 41 to 42 of 42

Thread: where did you get your engine for your swap?

  1. #41
    i bought an 04 6.0 from a rolled gmc denali for 750 from a guy i met at the shop i work at. it only had 18k miles. clean. he was gonna swap it into a 68 camaro but went the big block route. i ended up selling the 6.0 for 1400.00 to a guy who wanted to replace his 5.7 ls1 in a camaro.
    i found a 5.3 out of a silverado. paid 100.00 for the complete motor. searched craigslist and bought a harness, ls6 oil pump, ls6 timing chain w/ gears, set of new rockers all for less than 200 (also got extra intakecomplete with injectors and fuel rail)
    i used craigslist to source the 5.3.
    im rebuilding it completely: new gasket set, piston rings, crank bearking, rod bearings, cam bearings.
    a friend of mine in texas is porting and polishing my stock heads, getting an ls6 cam, ls6 valve springs, getting bigger valves etc.
    i'll have about 1300-1700 in the motor once its said and done.. still gotta find an ls6 intake though.

    good luck with your build man.
    1990 mazda b2200 SFBD one off frame, 6.0 lq4/6l80e, 2002 narrowed gmfs rearend w/ discs, 2003 gm 2" drop spindles w/ stock gmfs hubs/rotors/calipers, airbagged w/ ss re7's 22x8" front, 22x10" rear


    http://i253.photobucket.com/albums/h...renderinf1.jpg

  2. #42

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts