+ Reply to Thread
Page 3 of 3 FirstFirst 1 2 3
Results 21 to 23 of 23

Thread: cleaning inside of header

  1. #21
    Join Date
    Jun 2005
    Location
    Way up in North Dakota
    Posts
    346

    Better yet

    http://www.travers.com/product.asp?R...1%3D53-014-635

    These come in many sizes and with different mandrels, Merit bore polishers, just have to find a flex shaft. Maybe make one out off a plumbers drain snake, weld the mandrel on the end [which might crack on the spring steel], or make a mandrel that uses set screws to clamp on the snake. Insert the snake in a flexible tube like a hard plastic water tube to control the snake. Make "custom" lengths.

  2. #22
    Join Date
    Mar 2003
    Location
    San Antonio, TX
    Posts
    11,038
    that's a nice one!

  3. #23
    Join Date
    Sep 2010
    Location
    Texas
    Posts
    2,112
    Quit messing around, just weld it up under water, upside down in a circular pattern with the leads reversed.
    2013 EC Silverado aka redruM (Just a couple bolt ons.)
    2007 RC Silverado aka ?
    1998 Trans AM aka Red Dragon

    "Your pull your truck to the track on a trailer, I race you with a truck that pulled a trailer to the track."

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts