+ Reply to Thread
Page 1 of 43 1 2 3 11 ... LastLast
Results 1 to 10 of 429

Thread: AWD Conversion How-To

  1. #1

    AWD Conversion How-To

    This is what I did to mine. It is not perfect as each vehicle will vary some.

    4wd to AWD conversion how to.



    Step 1. Locate parts.
    A. Parts needed.
    1. Front differential + new fluid might as well change it now.
    Part Number:?????????
    2. Front Drive Shaft from Silverado SS or Denali or Escalade
    Part number:15186002
    Rear drive shaft will work if you have an original GM yoke depending on your application. If you have vibration you need a longer shaft.
    3. AWD Transfer case. Transfer case Fluid + transmission fluid.
    Part Number:NVG149 / Fluid part number 88861800
    4. Cup to replace 4wd switches in dash.
    Part Number:?????????
    5. Zip ties.

    Step 2. R&R front Diff. Leave front Drive shaft out till transfer case changed. Locate front diff actuator wires and plug. Tape up plug and pull it out of the wire loom and zip tie it out of the way some where. You could cut it but I did not cut mine and don't know what would happen with the pcm or codes.
    Step 3. R&R Transfer case.
    Step 4. Locate Speed sensor connector that plugged into Autotrac transfer case. There will be three I think. Only one will plug into the awd Transfer case. Zip tie the others out of the way. You may want to tape up the plugs to keep water out.
    Step 5. Put driveshafts back in. Make sure you put the SS shaft in not the old one. I reused my rear shaft. I am not sure if this will work for everyone because my shaft was custom made.
    Step 6. Locate and unplug the Transfer Case control Module or TCCM. Unplug and remove the 4wd switches. Replace the 4wd switches with cup. Unplugging the TCCM eliminated any trouble codes for me. I am not sure if it will for you.



    Pics of the differences in Differentials.


    The picture below is what the vent looks like on awd front diff. A technical bulletin for cold weather changes this. Info can be found at the link to Denali forums. If you get a diff with the white tube do not worry about the bulletin as it will not apply to your diff.



    Pics of different drive shafts.



    Side notes:
    Simply unplugging front actuator on 4wd diff wont work. It will just free spin. This will kill the awd transfer case. It might be possible to shift it into 4wd then unplug the actuator. I am not certain of this. It is worth a try. I did not try it because I changed gear ratios during the swap.

    AWD /Autotrac / Manual 4wd
    The awd transfer case is a 62/38 split I think. It uses a viscous coupling to be awd. It is not selectable.
    The Autotrac transfer case is a selectable unit. Auto 4wd/ 4 Hi and 4 Low. Auto 4wd will engage 4wd when the rear wheels slip. In my truck driving on dry pavement caused loud growling and once the rear wheels lost traction the front wheels would violantly grab and loose traction. Awd is smoother, quieter and less violent.
    Manual 4wd has 2 wheel drive mode and 4 hi and 4 low.

    Pros of AWD transfer case.
    Traction all the time.
    Better tire wear.
    Safety in inclement weather.

    Cons of AWD
    I have heard of a few breaking.
    Not selectable.
    No smoky burnouts.
    No 4 Low.

  2. #2
    Join Date
    Apr 2008
    Location
    Birmingham, AL
    Posts
    3,626
    maybe a dumb question... but why?? whats the advantage of AWD over 4WD
    01 Silverado

  3. #3
    Join Date
    Jan 2009
    Location
    Augusta, Ks
    Posts
    3,246
    Quote Originally Posted by mitch cobb racing View Post
    maybe a dumb question... but why?? whats the advantage of AWD over 4WD
    Pros of AWD transfer case.
    Traction all the time.
    Better tire wear.
    Safety in inclement weather.

    Cons of AWD
    I have heard of a few breaking.
    Not selectable.
    No smoky burnouts.
    No 4 Low.
    2000 Silverado ECSB- 5.3 CAI, Pacesetter LTs, ORY- Pipe, Magnaflow XL, E-fan, Ported T/B , Nelson Tuned, Built 4l60e, Circle D Stall, 3.42s G80, 2-4 Drop, Hertz Highs, Rockford 501s

    2004 Buell XB12s

    Quote Originally Posted by LamboDoNoMo View Post
    "Never give up, NEVER BACK DOWN!!!"

  4. #4
    Join Date
    Jun 2009
    Location
    Washington DC
    Posts
    1,812
    damn thats a purdee truck

  5. #5
    Quote Originally Posted by Mang213 View Post
    damn thats a purdee truck

    Thanks.

    I went awd to gain some street traction. Part throttle pulling into traffic I would smoke the tires. Now It just launches.
    99RCSB Broke because I wasted thousands and thousands of dollars on my truck.

  6. #6
    Join Date
    Apr 2008
    Location
    Birmingham, AL
    Posts
    3,626
    but couldnt you just put it in 4WD?
    01 Silverado

  7. #7
    Join Date
    Aug 2008
    Location
    North Texas
    Posts
    12,078
    4WD is not for dry pavement and will bind in turns. Sure it will work in a straight line.

  8. #8
    Join Date
    Dec 2003
    Location
    Azle,TX
    Posts
    3,682
    GMC trucks with cowl hoods are slow and ugly!
    Vortec Performance Tuned
    LQ9 built 4L60 LTs and a billion miles on the speedo!

  9. #9
    Join Date
    Nov 2008
    Location
    Paris, Texas
    Posts
    1,732
    nice job zeake.


    the front diff fluid P/N: 89021671
    left side cuddy hole in dash P/N: 15732033

  10. #10
    Join Date
    Jan 2008
    Posts
    8,031
    damm nice truck and write up

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts