What fittings do you have on your tank? Pics? Some pumps have the same fittings as the Corvette filter, others are screwed onto the pump. You can use compression fittings on the 5/16 and 3/8" lines with a -6 AN fitting. I've used simple fuel injection hose available in 1' sections at Autozone or Oriellys to do a few trucks.
Last edited by RedHeartbeat; 01-09-2012 at 08:22 PM.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
i'll have to take some pics tomorrow. it has the feed line that goes into the factory truck filter then up a little closer to the motor the return line. i didn't know if they had fittings or adapters to screw into the factory fittings or if i have to cut them back & use fittings like these, http://www.ebay.com/itm/6-5-16-tube-...#ht_500wt_1180
& make a line to go from there to the vette filter.
Posting Permissions
Reply With Quote