Any Ideas what could be wrong?Originally Posted by DBRODS
DANIEL CAMMED SS 13.46 @ 98.17-- 8.58 @ 80.31
2003 Silverado SS / LQ9 6.0L / Wheatley 93 Octane Tune / 224/228 .581 .588 110lsa / Patriot Gold Dual Springs / Comp Hardened Push Rods / Circle D 3800 stall / Pacesetter LT's / 4:10 Gears / Transgo HD-2 Shift Kit / K & N Cold Air Intake / Corvette Servo / Aeroforce Interceptor / Autometer Narrorband(Wideband on the way) / Mobile 1 Synthetic / Single Chamber Flows with X Pipe / Cats Delete with Cutouts
sounds like it spun or is spinning a few bearings..more than likely rods..
They did everything but put the motor in. I put the motor in and intake, and all that stuff. It ran great for 1700 miles. Filter as in oil filter? No.
DANIEL CAMMED SS 13.46 @ 98.17-- 8.58 @ 80.31
2003 Silverado SS / LQ9 6.0L / Wheatley 93 Octane Tune / 224/228 .581 .588 110lsa / Patriot Gold Dual Springs / Comp Hardened Push Rods / Circle D 3800 stall / Pacesetter LT's / 4:10 Gears / Transgo HD-2 Shift Kit / K & N Cold Air Intake / Corvette Servo / Aeroforce Interceptor / Autometer Narrorband(Wideband on the way) / Mobile 1 Synthetic / Single Chamber Flows with X Pipe / Cats Delete with Cutouts
oil pump not centerd on crank...... would cause all of above..... it is very important on these motors to center the pump.... hope it is something simple like this.... but the bad part is if there was metal in oil.... all bearings need be replaced.... cam included... and hope it didnt scar up crank.... Good luck.
single digit street truck
for build info
http://www.ls1truck.com/forums/my-ga...cs-garage.html
The best advice I have ever heard:... Only take B( . Y . )ST advice from someone that is CURRENTLY running a turbo setup close to, or bigger than what you want......
The shop said it had a warranty if it was anything they did. And they put a new oil pump on it. I had a sealed long block and just dropped it in the truck. So it cant be anything I did.
DANIEL CAMMED SS 13.46 @ 98.17-- 8.58 @ 80.31
2003 Silverado SS / LQ9 6.0L / Wheatley 93 Octane Tune / 224/228 .581 .588 110lsa / Patriot Gold Dual Springs / Comp Hardened Push Rods / Circle D 3800 stall / Pacesetter LT's / 4:10 Gears / Transgo HD-2 Shift Kit / K & N Cold Air Intake / Corvette Servo / Aeroforce Interceptor / Autometer Narrorband(Wideband on the way) / Mobile 1 Synthetic / Single Chamber Flows with X Pipe / Cats Delete with Cutouts
yep, hope they stand behind it.....
single digit street truck
for build info
http://www.ls1truck.com/forums/my-ga...cs-garage.html
The best advice I have ever heard:... Only take B( . Y . )ST advice from someone that is CURRENTLY running a turbo setup close to, or bigger than what you want......
Posting Permissions
Reply With Quote
