Gonna pick it up from the shop tomorrow after work and take it to get bored and honed. taking it out to 3.898. Pistons/rods on the way along with some 241's with PRC dual springs. Looks like this build is gonna cost me right around 900. I don't think it's that bad. That's including all gaskets, bolts, fluids and any other misc things that I needed to get for it. Not sure how much it's going to cost to get the heads milled but I'll find that out tomorrow.

Will take pics when I start reassembly.

On another note, I figure out that the edges inside the block are extremely sharp!