DBRODS & Mini's ( skeets 4 Link )

[HarleyDave]

Man ,I want one! Just to far to drive, Hopefully he'll build a kit some day.

[Duct_tape123]

A kit would be nice, but way to complicated. I was reading another thread of Jon's where he was explaining it and it was alot more complicated than you think. If your off on measurements bad stuff can happen. Just make the trip, I bet it will be worth it.

[Low_LQ4]

Looks great congrats on the upgrade.
I want one. Where are you located?

[conekiller01]

Looks great congrats on the upgrade.
I want one. Where are you located?

Granger Texas lol

....about 45min northeast of austin/RR

[bangbangskeetskeet]

That place produces nothing but top notch work man. Every time I see stuff come out of there it makes me want to drive out asap and get work done.

One question I have...is there much difference in this vs a triangulated 4-link, other than 2 bars being triangulated?

[408.Luke]

Very nice and congrats skeet, the road grime from ur frame is still all over the side of my truck , u wana come over and wash it?

[SCIV]

Granger Texas lol

....about 45min northeast of austin/RR

Circleville.

And you must drive pretty slow.

[DBRODS]

Here ya go Skeet. Have a nice Friday and see you tomorrow.

[SCIV]

Effin sweet as usual Jon.

You da man!

[conekiller01]

Circleville.

And you must drive pretty slow.

ehhh im from holland about 15 minutes south of circleville so i guess my ticker is off.... haha but then again my truck doesnt run 10's or handle like a indy car either lol

and by the way that is AWESOME!!!!...you wouldnt happen to do the thing like resturants where when you get done and i dont have any money i can just roll up my sleeves and wash some trucks or something huh? jk but that is very precise and rediculous! i like...