600hp Raptor

[r.barn]

Howdy all,

Havent been around for a long time cause I got rid of my Tahoe, but figured fellow truck nuts would get a kick out of my latest project.

Picked up a 2012 Raptor this past summer and jumped in feet first ordering a Whipple for it and some other misc. mods.

Just finished the Whipple install and got it tuned. This new 6.2L from Ford is pretty impressive.

Baseline off the dealer lot dyno made 335rwhp and 352rwtrq at 5,700. Not bad for a "stock" motor and tune with a paper filter in the box.

With the 2.9L Whipple and 3.375 pulley it made a little over 10psi and 497rwhp and 469rwtrq through complete stock exhaust, muffler and all. I upgraded the intercooler system with an AFCO heat exchanger with fans and a better Meziere water pump.

The truck will light up 35" BFG AT's and go fish tailing around corners like a sports car. The sound is awesome.

[o2camaross]

sounds really good. Why does the title say 600hp? I see less than 500

[kerrige]

Typo I'm guessing, but that thing is awesome!

[cjriojas]

I think the 600 is at the crank

[o2camaross]

gotchya. sounds really good!!

[r.barn]

Yeah, crank hp. give or take. Might be a little over 600, but dyno numbers always vary.
600 X 82% = 492rwhp

Thanks. Truck is a blast to drive. The low end torque launches it out of the hole like a bat out of hell. The whipple is insanely loud at WOT.

Gonna try and take it down to the Qrt mile track after Thanksgiving and see what it will run. I'm guessing mid-13's at about 100mph.