Edelbrock manifold question

[SLDPULR]

So I have been looking at going to a new intake manifold. I already have a cam, long tubes, Tune and will be going to forced induction sometime in the future. I have been looking at the FAST intake (the tall one for the lsx). But I also like the edelbrock PRO-FLO Xt. I was curious what else I would need to use the edelbrock intake. It says it is for a 90mm. Will I need an adapter plate? Do I have to swap the water pump and grind down the accessory brackets like I would if I was changing over to a ls1/ls6 manifold? Will the fuel rails etc work. Is it taller or shorter then the factory 5.3 manifold. Just trying to get a list together so I can do the swap on a weekend and have my truck back on the road by a Monday in time for work. Also if anyone has any pictures of one installed that would be great.

[408Lbb]

U will need a 90mm tb. And u have to use the edelbrock fuel rails kit #24-3629. Everything else is plug and play. I run the same setup. Except i use the edelbrock tb two

[SLDPULR]

How do you like the 90mm throttle body?

[SLDPULR]

Also if there was a way you could post a picture I would really appreciate it.

[408Lbb]

Will do and i love it

[408Lbb]

.

[SLDPULR]

Holy Crap that looks good. Thanks bud!

[408Lbb]

No prob