Check your overdrive carrier and overrun clutches, It doesn't sound like the carrier is seating completely in the overrun clutches. I've had those fight with me before.
Type: Posts; User: slow94
Check your overdrive carrier and overrun clutches, It doesn't sound like the carrier is seating completely in the overrun clutches. I've had those fight with me before.
The light blue/black stripe wire goes to your speedometer
The red/white stripe wire goes to your cruise box (if you're using cable throttle, you'll need this hooked up, if drive-by-wire you dontl...
I believe that dark blue wire went back to the tbi pcm, if you removed the tbi pcm, id just cap that one off
I clipped the wire from the box, and it works fine
yes, the light blue wire goes to the speedometer, the dark blue feeds something else
The light blue goes to the guage.
http://pbr992.photobucket.com/albums/af48/rreynolds84/20130801_215234_zps2aec0dc8.jpg?t=1375412060
http://www.the12volt.com/12voltimages/pos2neg.gifhttp://www.the12volt.com/12voltimages/pos2neg.gif
You would hook the 12v output(that went to the tbi pcm) from the transfer case into pin 86, when...
The way vss is setup in 94, is the twisted pair wires from the vss going straight into that drac box, then the decoded speed signal is fed to the guages, tbi pcm, abs, and cruise. So when you hooked...
All of this is assuming your still running the 94 ifs and np241 that came in the 94 originally
Just to make sure we're talking about the same thing, its the sensor in the middle of this picture? If so, it has a seperate harness and will need to be hooked up or you will not have 4wd. This wire...
The first sensor/switch on your transfer case is used to engage the 4wd actuator in your front axle, it also illuminates your floor shifter, and signals the pcm when you have shifted to 4lo, it also...
I found my diagrams, here's how mines wired.
Green wire pin 50 on the green or red pcm connector, then behind your glove box, find the light blue wire coming out of the drac, pin c15(this feeds...
Where do you have the speedo wire tied in? On my 1994 I originally hooked it in before the drac/buffer, and it wouldnt read correct. I bypassed it and went straight into the cluster bypassing the...
There are tons of 2 door gen 3 conversions out there, but I cant say that ive ever seen one with awd, I think its just a cost verse gain thing(goin from 4wd to awd). It would be a cool idea though. I...
How much would you need for dirty dingo ac bracket?
I don't have a pic, but there is a thick ground that went on the back of the pass. Head, then two on the front of the intake, mine had one on an intake stud and the other was on the t-stat bolt
I had a problem on my 94 with intermittent wipers, it turned out to be a broken wire on one of the 2 groundsthat went on the front of the intake. Could be worth looking at.
Anyone have experience with the Lsbrackets.com R4 bracket?
It looks like a decent kit from the pictures, I especially like the tensioner. I used another kit on a previous swap and was not happy with...
I've been stuck at work late the last week or so and haven't gotten as much accomplished as I like, but here are a few updates as to where it sits:
Intake and harness installed...
Engine was clean inside, so I'm keeping it simple
CRANE CAMS 1449041 210/218 .551/.551 114
Pac 1218 springs
Comp hardened 7.4
Stock truck intake with 8.1l injectors
Probably rig up some sort of...
The tbi 350 turned out to have an appetite for oil, to the tune of about 3 qts in 200 miles. Not surprised considering that the oil change sticker was 15000 miles overdue when I drove it home and the...
I bought the hinge pins and bushings off the shelf at a local o'reillys, like $8 or $10 I think
Phase 1 involved the following:
Pulling the deceased 4l60e and replacing it with a blueprinted 2006 4l80e with a transgo hd-2 kit and some sonnax upgrades(completed, hole in the hardline led to an...
I picked this blazer up back in 2011 for $700, it was very dirty and had an extreme lack of maintenance, but the body was relatively straight and the interior was not destroyed.
This is the day I...
Any update on this build?