Did you get an answer or solution to your problem?
If not, probably need to raise the idle a little
Type: Posts; User: slicpartna
Did you get an answer or solution to your problem?
If not, probably need to raise the idle a little
bow tie fans
I finally completed my 5.3 swap in my suburban
it has been tuned and the engine runz and soundz great
Im ready to add a/c back though
Alabama summers are brutal
Temps of 98...
Hey farmtruc
Thanks for the reply
Is there a set screw dbw throttle bodies?
I have a 5.3 that I swapped into my obs
I put an ls6 intake on the engine and swapped the cam.
I did have the ecm tuned for the cam. (mail order)
The truck runs and drives fine but once the...
I have an analog cluster
1997 chevy sub with a 05 5.3 swap
05
I swapped in a LS engine in 97 suburban
Used thinned out factory harness with psi harness.
My voltage gauge, Oil pressure, tac and speedometer is not working.
the pink wires behind the...
I would suggest removing the core support
You will not have to raise the engine/trans that high up
The 02 sensors are installed, the rears have been deleted
I swapped in a 5.3 in my obs
After the engine begins to warm up it cuts off
I dont have the exhaust hooked up yet still with open headers
I get a code for both oxygens sensors (lean conditon)...
Awesome!!!!!
What is the difference in the resistors
I read that all I needed was the tan wire for the oil pressure gauge
Im going to reconnect the wires that I cut going to the oil pressure sensor
I hope that will get the gauge working
I swapped in a 5.3 in my obs
I used a PSI wiring harness with the swap
I hooked the tach wire from wiring harness to the white wire on firewall connector ( c100)
Can someone help diagnose why...
Im using the stock 97 sensor and 97 stock wiring harness for the gauges
I put a 5.3 in my 1997 obs
Im using the factory harness
Im stumped on why is my oil pressure gauge doesnt work
I know I have oil pressure because I checked it with a mechanical gauge...
Im working on a 5.3 swap into my obs
while I have the motor broke down I wanted to swap the oil pump. is the Melling high volume oil pump still the pump of choice or is there a better one?
Good deal, looks good too
Hey fellas
Im in the final stages of my 5.3 swap into my 97 chev suburban.
I ordered a psi conversions stand alone wiring harness
Where is a good resource to figure out the 1997 chevy sub...
That blows about the low end knock
But you scored with lq9
Nice build doc
Idk doc
Im running ls6 intake with associated injectors
The 5.3 dbw throttle body
Should I use the 5.3 maf or ls1 maf,
Or there no difference in the two in terms of wiring?
Is there any...
I swapped a 5.3 into my 97 burb
I need a wiring harness
I reached out to nelson but they said it might be 3-5 weeks since they are training a new wiring tech.
What other reputable options is...
I got a 05 5.3
Im installing a temp sensor on the passenger side head, im using the s and p adapter
Should I use antiseize or teflon paste on the adapter?
Thanks
Good deal!!!
Nice parts there