Search:

Type: Posts; User: slicpartna

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    3,557

    Did you get an answer or solution to your...

    Did you get an answer or solution to your problem?
    If not, probably need to raise the idle a little
  2. Replies
    1
    Views
    7,274

    A/C after 5.3 swap

    bow tie fans

    I finally completed my 5.3 swap in my suburban
    it has been tuned and the engine runz and soundz great

    Im ready to add a/c back though
    Alabama summers are brutal
    Temps of 98...
  3. Replies
    3
    Views
    2,985

    Hey farmtruc Thanks for the reply Is there a...

    Hey farmtruc

    Thanks for the reply
    Is there a set screw dbw throttle bodies?
  4. Replies
    3
    Views
    2,985

    Engine dies on deceleration after warm up

    I have a 5.3 that I swapped into my obs
    I put an ls6 intake on the engine and swapped the cam.
    I did have the ecm tuned for the cam. (mail order)

    The truck runs and drives fine but once the...
  5. Replies
    8
    Views
    3,567

    I have an analog cluster 1997 chevy sub with...

    I have an analog cluster

    1997 chevy sub with a 05 5.3 swap
  6. Replies
    8
    Views
    3,567

    05

    05
  7. Replies
    8
    Views
    3,567

    instrument cluster

    I swapped in a LS engine in 97 suburban

    Used thinned out factory harness with psi harness.

    My voltage gauge, Oil pressure, tac and speedometer is not working.

    the pink wires behind the...
  8. I would suggest removing the core support You...

    I would suggest removing the core support
    You will not have to raise the engine/trans that high up
  9. Replies
    3
    Views
    2,315

    The 02 sensors are installed, the rears have been...

    The 02 sensors are installed, the rears have been deleted
  10. Replies
    3
    Views
    2,315

    engine dies after warm up

    I swapped in a 5.3 in my obs

    After the engine begins to warm up it cuts off
    I dont have the exhaust hooked up yet still with open headers

    I get a code for both oxygens sensors (lean conditon)...
  11. Replies
    94
    Views
    38,419

    Awesome!!!!!

    Awesome!!!!!
  12. Replies
    12
    Views
    5,192

    What is the difference in the resistors

    What is the difference in the resistors
  13. Replies
    6
    Views
    3,941

    I read that all I needed was the tan wire for the...

    I read that all I needed was the tan wire for the oil pressure gauge
    Im going to reconnect the wires that I cut going to the oil pressure sensor
    I hope that will get the gauge working
  14. Replies
    12
    Views
    5,192

    no tachometer

    I swapped in a 5.3 in my obs
    I used a PSI wiring harness with the swap
    I hooked the tach wire from wiring harness to the white wire on firewall connector ( c100)

    Can someone help diagnose why...
  15. Replies
    6
    Views
    3,941

    Im using the stock 97 sensor and 97 stock wiring...

    Im using the stock 97 sensor and 97 stock wiring harness for the gauges
  16. Replies
    6
    Views
    3,941

    oil pressure gauge

    I put a 5.3 in my 1997 obs

    Im using the factory harness
    Im stumped on why is my oil pressure gauge doesnt work

    I know I have oil pressure because I checked it with a mechanical gauge...
  17. Replies
    1
    Views
    1,497

    5.3 swap into obs

    Im working on a 5.3 swap into my obs
    while I have the motor broke down I wanted to swap the oil pump. is the Melling high volume oil pump still the pump of choice or is there a better one?
  18. Thread: It's done!

    by slicpartna
    Replies
    4
    Views
    2,253

    Good deal, looks good too

    Good deal, looks good too
  19. Replies
    3
    Views
    1,803

    1997 chev sub wiring harness help

    Hey fellas


    Im in the final stages of my 5.3 swap into my 97 chev suburban.
    I ordered a psi conversions stand alone wiring harness
    Where is a good resource to figure out the 1997 chevy sub...
  20. Replies
    26
    Views
    12,582

    That blows about the low end knock But you...

    That blows about the low end knock

    But you scored with lq9

    Nice build doc
  21. Replies
    5
    Views
    2,206

    Idk doc Im running ls6 intake with...

    Idk doc


    Im running ls6 intake with associated injectors
    The 5.3 dbw throttle body

    Should I use the 5.3 maf or ls1 maf,
    Or there no difference in the two in terms of wiring?

    Is there any...
  22. Replies
    5
    Views
    2,206

    aftermarket wiring harness

    I swapped a 5.3 into my 97 burb
    I need a wiring harness
    I reached out to nelson but they said it might be 3-5 weeks since they are training a new wiring tech.

    What other reputable options is...
  23. Replies
    2
    Views
    1,427

    temperature sensor

    I got a 05 5.3
    Im installing a temp sensor on the passenger side head, im using the s and p adapter
    Should I use antiseize or teflon paste on the adapter?

    Thanks
  24. Replies
    26
    Views
    12,582

    Good deal!!!

    Good deal!!!
  25. Replies
    143
    Views
    64,606

    Nice parts there

    Nice parts there
Results 1 to 25 of 55
Page 1 of 3 1 2 3