2000 Silverado 5.3L 2WD 1500 RCSB w/ ~165Kmi - all stock
Fuel pressure still just under spec after new pump and more...
I replaced the fuel pump (AC Delco OEM) and the new pump made only a...
Type: Posts; User: 2Kchevy
2000 Silverado 5.3L 2WD 1500 RCSB w/ ~165Kmi - all stock
Fuel pressure still just under spec after new pump and more...
I replaced the fuel pump (AC Delco OEM) and the new pump made only a...
Thanks for all the replies. To answer all the questions and ask a few more....
It has been 15K since I last rotated and it was 12K before then, so not as often as I thought.
The last set of...
Hello.
2000 Silverado 1500 RCSB w/ ~123Kmi
I'm running 265/60/18 Yokohama G52s on 18x8 Centerline wheels
1st issue is cupping/feathering....
My tires have about 30Kmi and the edges of the...
Thanks to all.
The antenna grommet was my next guess as well, which requires the front fender to be removed from what I can tell. If anyone knows an easier way to check the antenna grommet let me...
I originally posted under "appearance" but maybe this post is better suited here.
I have a 2000 RCSB silverado 1500. Pics of the issue attached below. The 2 pics of the kick panel are rotated 90...
No need to replace the entire shift lever. I have a 2000 RCSB silverado 1500 and just ran into the same issue a few months back. The tow/haul worked intermittently.
You'll need a small torx...
Hello.
I have a 2000 RCSB silverado 1500. Pics of the issue attached below. The 2 pics of the kick panel are rotated 90 degrees, so you have to turn your head...they are oriented properly in my...
I also checked out the Trick fans.
Do the Trick fans wire into the PCM or are the fans controlled by a temp. sensor?
Is the 34" radiator a simple drop-in for any 2000 silverado?
Thanks.
Do I have to buy or make any special hardware or brackets to install LS1 fans?....or does everything needed come with the fans when purchased or pulled from the car?
Thanks.
Hello,
I want to upgrade to E-fans for my 2000 5.3L silverado.
I already have a Nelson tune, so I plan to buy the Nelson harness and run the fans using the PCM, unless some other harness is...
Hello.
I have a 2000 Silverado RCSB 5.3L w/ ~103K mi.
I just noticed a slight, intermittent squeak coming from under the hood at idle and slow highway speeds (55mph @ 1500 rpm or so). Both the...
well, I guess I'll keep 'em at 0.060" unless I hear a compelling reason not to.
If the change from platinum to iridium caused the change in the gap, then it still seems odd that now even platinum and copper aftermarket replacement plugs are gapped to 0.040" as well....at least...
About 3yr. ago I changed the factory plugs on my stock 2000 5.3L w/ NGK Iridium IX plugs. At the time these plugs came w/ an 0.060" gap and my Haynes manual (bought ~5yr. ago) also has an 0.060" gap...
I went with the rebuild...ran about $130, 5-day turn, comes w/ a 5yr. warranty, and they had a kit to replace the torx screws with SS allen head screws. Been installed for a few weeks now and so far...
Hello,
I have a 2000 silverado 5.3L w/ just over 100K mi.
For the past several months, both my ABS and red brake light illuminate on the instrument panel while driving....both light up at the...
So Sat. I pulled the drive shaft, closely inspected all U-joints, and felt for slack in the diff. All checked out OK, but I did notice the yoke could use some grease.
I went ahead and let the...
Hello.
I can hear a clank that seems to be coming from the drive shaft whenever I start and stop moving. I also sometimes hear it when I shift from Park to Reverse.
I can not feel any slack in...
Thanks for the advice.
I'll probably go ahead and do a flush as well after the new pump is on.
Looks like I've got another project lined up for the holidays. We'll see if I run into any...
Last winter I noticed a few drops of coolant on the garage floor now and then, after my truck had been sitting for at least a few days and once the weather got below 40F or so.
Now with this...
Well, I know it's been quite a while (~5 months) but I figured I would at least report back what the final problem was.
So turns out one of the new sensors I had purchased back in Jan. was bad. ...
Back in Jan. I originally bought the same orange Felpro gasket from Autozone, but then somewhere I had read that GM changed the gasket slightly...so just being paranoid, I returned the Felpro and...
That's good to know that I can reuse the gasket w/o risking any vacuum leaks. Somehow back when I originally replaced the knock sensors, I got the impression the gasket had to be replaced as well. ...
Yeah, that would definitely help narrow it down. If I go that far I'll go ahead and replace the front sensor, since every time the intake manifold is removed it costs about $100 just for the gasket....