Never mind, found the problems out myself. The temp sender was bad, put in new one works perfectly. Trans problem was that I had accidentally cut the power wire to the trans pcm when I weeded out...
Type: Posts; User: westofb
Never mind, found the problems out myself. The temp sender was bad, put in new one works perfectly. Trans problem was that I had accidentally cut the power wire to the trans pcm when I weeded out...
I have a 95 c1500 with an 01 4.8 and 4l60e (both from same donor vehicle, trans is new but spec'd for donor truck. My first issue is coolant temp sensor throwing code po118 coolant circuit high,...
Think I will hook ls vss signal wire directly to the instrument cluster and see if I can figure out where to hook it directly to the cruise control module, then shit can the oem ecm, I can't see any...
Found my problem, during the swap I eliminated my abs (didn't work anyway) and removed all remnants of it. I then replaced my rusty booster and master cylinder and got set up from an 88-91 obs...
Drove truck today, maiden voyage, and all gauges work except for the speedo. I have looked far and wide and have yet to find info specific to the 1995. I had pinouts for the 95 ecm and wired the ls...
Now I'll check continuity and figure out which is which, thanks.
Just about to complete my ls swap in my 95 obs truck and am having an issue with my electric fans. I had my computer set up by Brendan at LT1 Swap and had him enable fans 1 and 2. I bought a set of...
thanks
I am quickly approaching the end of my ls swap into my 95 2wd ext cab, but have yet to make final connections from the ls harness to the truck to get gauges and speedo to work. I do have the motor...
Haven't yet finished my ls to 95 obs swap (work in progress). I was bound and determined to use the donor truck (01 Silverado) radiator and expansion tank so that it work as designed for the 01. ...
I am part way through my swap as well. I used throttle cable from my donor 2001 truck. It is made to fit a round hole, where the one on my 95 was rectangular hole. I used cut off wheel to cut the...
Actually the bell housing bolts are 10mm 1.50 pitch, just bought some 80mm long to hang engine on stand.
As I research this, the more I get confused (no doubt overthinking things again). Was looking at some info on fuel supply, lots of info on how to use corvette filter for returnless fuel system??? ...
One of these threads for a 93 or 94 I read that you pitch drak box splice the red and blue wire to the vss wire from the ls harness to enable the speedo and cruise. This hold true for the 95 as...
Hello, I am new to this site and have been searching for some info to no avail (maybe I'm not sharp enough to find it!). I have a 1995 C1500 that has the trans going out, so I figured, what an...
Hello, new to the site, lots of info to digest here...which is great. I am in the part hoarding and planning stage of my build. So far I have gutted a 2001 base Silverado ecsb rust bucket. Kept...