Search:

You can go with either of the throttle body's it up to you. I went from a manual trans to an automatic but I think you have to make the hole bigger on the flex plate im not to sure. But good luck...

I finally got to drive my truck around the block. It still nerds the exhaust done but I have to wait until I save some money. I try and post a video

Lookin good man.

How did you guys get the pcm to fit in the glovebox? I tried to get mine in there but it doesnt fit.

I converted my truck to v8 motors mounts. It was a pain in the ass and i just used stock 350 mounts. Hope that helps i finally got it running just havent had time to work on it some more. Good luck...

Well i got the vats disabled and its runs for a little bit longer but it still dies. Any ideas what it can be?

Hey guys i finally went to start my truck and it fires up for about 3 seconds then shuts off. Could this be the vats? i checked the fuel pump relay with a test light and it get power then shuts off....

Thanks man

does the slip yoke from a 700r tranny fit the 4l60e transmission.

Welcome from Arizona.

Can someone tell me how the dirty dingo mount go on i am lost here. I have the v8 motor mounts and the brackets.

i had some questions regarding what motor mount to use. do i just get the v8 motor mount?

I picked up my adapters today from dirty dingo. i should be able to pick up some more parts later on today.

6786

thanks guys! i am actually in San tan valley

i added to clutch switch to the to do list. i am having a friend take care of the harness and the ecu.

hello everyone i am getting ready to do a 5.3/4l60e swap in a 93 single silverado. that currently has a 4.3 and a 5 speed.

hello everyone i am going to swap a 5.3 and 4l60e from a 2002 Denali. my truck currently has a 4.3 with a 5 speed that have 265k on them. the trany is in its final days of smoky burn outs. lol i got...