Search:

Type: Posts; User: LOWnEASY

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Thread: Wtb cam

    by LOWnEASY
    Replies
    0
    Views
    844

    Wtb cam

    In the market for another cam.
    Some were in the mid 230 to low 240 with a 112 ish lsa.
    Lmk what you have thanks
    As always, the cheaper the better
  2. Thread: Wtb cam

    by LOWnEASY
    Replies
    2
    Views
    1,767

    Wtb cam

    Looking for a cam for a 5.3. Something in the 22x/22x rang with 108-112 lsa. 200-$250 shipped would be nice as well. Lmk what u got.
  3. Replies
    1
    Views
    1,025

    asa cam 226/236 trade for boost cam

    Have an gmpp asa cam for sale or trade. 226/236 110 lsa 525/525. 100-150 miles on it.
    Easy on the valve springs (can run ls6 springs and not worry about them for thousands of miles), sounds wicked,...
  4. Replies
    5
    Views
    1,474

    Ahh, didn't know that. Sorry

    Ahh, didn't know that. Sorry
  5. Replies
    5
    Views
    1,474

    So the bolts are bottoming out? If it's the...

    So the bolts are bottoming out?
    If it's the factory 6.0 bolts, and was in front of an auto, it most likely had a flex plate spacer that's .4 thick

    I had a nv3500 5 speed behind a 4.8 and used...
  6. Replies
    4
    Views
    2,339

    How does that thing shift 5500+? Mine didn't even...

    How does that thing shift 5500+? Mine didn't even like 3500+ rpm.
  7. I second the 87+ tanks, my 95 4.8/4l80 gets...

    I second the 87+ tanks, my 95 4.8/4l80 gets starved of gas under hard launches will 1/2 or less tank due to the gas all going to the back. Full down to 1/2 is fine.
    Those tanks are setup to run a...
  8. Replies
    1
    Views
    995

    starter cranks with key off

    My 4.8 keeps cranking with the key off but I can disconnect the battery then connect it back and it doesn't do it again until I hit the key. Wtf is up with it? Solenoid? Relay?
  9. I'll take the wideband Friday if you still have...

    I'll take the wideband Friday if you still have it.
  10. Replies
    9
    Views
    2,984

    Can't believe no one has got this. This guy is...

    Can't believe no one has got this.
    This guy is a good seller too!
  11. Thread: wtb: cam

    by LOWnEASY
    Replies
    5
    Views
    1,476

    I'm hoping it works good with BOOST! Haha. Not...

    I'm hoping it works good with BOOST! Haha. Not going for max effort, but some say what adds power N/A will add power F/I,
    Told the wife I "had" to have HP tuners to tune for the cam(little does she...
  12. Thread: wtb: cam

    by LOWnEASY
    Replies
    5
    Views
    1,476

    Bought the one from kerrige! Thanks

    Bought the one from kerrige! Thanks
  13. Thread: wtb: cam

    by LOWnEASY
    Replies
    5
    Views
    1,476

    Pm'd kerrige

    Pm'd kerrige
  14. Thread: wtb: cam

    by LOWnEASY
    Replies
    5
    Views
    1,476

    wtb: cam

    Looking for a good deal on a cam for around ~250-275. Needs something that will work good in a 4.8 so nothing over a 228 @ 50(and thats already pushing it) Prefer something with a 110-112 LSA. Don't...
  15. Replies
    2
    Views
    1,603

    gmt400 tank/pump baffle

    95 rcsb 4.8 4l80e
    Wot with half or less tank of gas, it cuts out. Full tank down to half does fine. My gas gauge bounces bad, so I can watch it hit E when I have a 1/2 tank. Any one know what I...
  16. Replies
    2
    Views
    1,598

    If its the one inch set back mounts, then the...

    If its the one inch set back mounts, then the transmission will remain in the stick location. If it isn't the 1" set back mounts then the trans cross member will have to be moved, front shaft...
  17. Replies
    1
    Views
    795

    Now it doesn't want to find any gear. I have to...

    Now it doesn't want to find any gear. I have to put it in park then slam it down to first (on gear shifter b&m floor shift) then back up to drive to go.
  18. Replies
    1
    Views
    795

    80e no first or no OD?

    I just got done swapping a 4l80e in my 95rcsb and all is well except I'm only counting 2 shifts and converter lock up. It has 3.42 gears and turns ~2000 rpm a 55.
    Does the converter only lock in...
  19. what happens to the login id on the diagram website

    What happens to the login I'd of the site that had all the diagrams that's in some peoples signature? Starts with am e, cant think of the name.
    It was
    User name: student
    Password: Watc
  20. Replies
    2
    Views
    540

    That would throw a code wouldn't it? What about...

    That would throw a code wouldn't it?
    What about a vacuum leak? I did have my intake off during the swap and put it back on with the original gaskets It idles around 550-600 rpm in park and its a...
  21. Replies
    2
    Views
    540

    4.8 spudder with NO cel

    Just got done with my 4l80e swap and got it buttoned up today. Took it on a test drive and it spits and spiders under 4k rpm and no power. After 4k it picks up and goes. Also_), there is no check...
  22. Replies
    0
    Views
    932

    862 heads, rails, tb,

    Pair of 862 heads, two inake valves need replaced (water sat on them and rusted up) other than that there in good shape. $100 shipped obo. Dont know what there worth so make an offer

    Truck fuel...
  23. Replies
    8
    Views
    2,807

    Wth happened? Looks like it was drilled or...

    Wth happened? Looks like it was drilled or something...
  24. Nelson will do it.

    Nelson will do it.
  25. Replies
    2
    Views
    1,134

    Actually, this is a 2wd unit. I figured out that...

    Actually, this is a 2wd unit. I figured out that it had a parking brake attached for a heavy duty box truck or van.
    I'm hopeing I can find a seal to fit, and remove the bearing.
Results 1 to 25 of 120
Page 1 of 5 1 2 3 4