Search:

Type: Posts; User: jaysonolson

Page 1 of 3 1 2 3

Search: Search took 0.17 seconds.

  1. Replies
    3
    Views
    697

    Did you do the learn procedure on the crank.

    Did you do the learn procedure on the crank.
  2. Replies
    2
    Views
    1,471

    how big is the gap between the flex plate and...

    how big is the gap between the flex plate and torque converter.
  3. It maybe stuck in limp home mode. I know if there...

    It maybe stuck in limp home mode. I know if there is a problem with the tps on the 2003 it will only allow you to go a max of 35 with very little power.
  4. Replies
    1
    Views
    1,174

    i have the same problem i found that it is do to...

    i have the same problem i found that it is do to low fluid levelyou may have the wrong dipstick or tube and not putting in enough fluid. It may also sputter in first and not hold overdrive.
  5. Replies
    4
    Views
    2,084

    find a 6.0 3/4 ton work van as it will be an...

    find a 6.0 3/4 ton work van as it will be an easier swap. it is not fbw and the computer, trans and wiring will be more basic.
  6. Replies
    4
    Views
    1,708

    check fuel pressure regulator first with pressure...

    check fuel pressure regulator first with pressure gauge.
  7. Replies
    1
    Views
    636

    nelson performance tune and check for exhaust...

    nelson performance tune and check for exhaust leaks at heads
  8. plug wires and plugs

    plug wires and plugs
  9. So for anyone out there that has had this issue....

    So for anyone out there that has had this issue. I figured out the problem. It was a melted fuse for the fuel pump. I replaced o2 sensors, afm, fuel filter, map, every thing and all it was was the...
  10. sounds like you are getting oil in the cooling...

    sounds like you are getting oil in the cooling system. maybe warped heads. Just a thought there aluminium and the can warp and crack just like any other car or truck after they been over heated. try...
  11. reconnect the ground and replace the intake...

    reconnect the ground and replace the intake manifold gaskets. clear codes and drive it around the block. then check the codes.
  12. 2003 chevy silverado fouling o2 sensor after closed loop

    Hi every one I am having trouble figuring this one out. The problem I am having is weird. The truck runs fine at start up. Then after I drive for a few minutes the truck starts to run ruff and...
  13. Replies
    3
    Views
    1,421

    there are going to be problems. make sure you...

    there are going to be problems. make sure you pull the power plant out complete even the fuel lines your going to need them, they com off the frame in a different spot on a two wheel drive. also you...
  14. Well guys figured out the problem with the truck....

    Well guys figured out the problem with the truck. Just in case anyone else goes through this. Well shorty before I noticed the problem I had went to the dealer and had an oil change done. You would...
  15. Replies
    3
    Views
    1,034

    I would stick with the stock tow rating of your...

    I would stick with the stock tow rating of your truck. Just because you put a few hundred pounds under the hood doesn't make its capacity any higher. If that was the case you could get a bunch of...
  16. I'm running the 5lbs. with the Langifelter gt2-3...

    I'm running the 5lbs. with the Langifelter gt2-3 cam. trying to play it safe. I used the 6.0 pulley from Magnacharger the one they suggested When i had the charger rebuilt with the latest 6th...
  17. Replies
    3
    Views
    1,609

    I'm running a Magnacharger kit. It's the same...

    I'm running a Magnacharger kit. It's the same stuff there putting in the stock 2016 Zo6 and Cameros. With the 6.0l a high lift cam some ported heads, long tube headers and a good valve train that...
  18. Replies
    1
    Views
    1,002

    do you have a neutral safety switch from a newer...

    do you have a neutral safety switch from a newer truck in there i be leave they rest at ground to send signal to the bcm to alow the truck to crank. Maybe the older truck use a positive signal...
  19. My engine new 6.0 supercharged the day I started it

    Here is a small video of the motor running the day i fired it up after the rebuild.

    https://youtu.be/VB7cu7IXjbA
  20. Replies
    408
    Views
    46,403

    Sticky: My name is my name I just like to keep it simple....

    My name is my name I just like to keep it simple. Jayson Olson
  21. I have only noticed that the 4x4 leaf has a small...

    I have only noticed that the 4x4 leaf has a small block in the back. Maybe they include that when you order the springs from gm because that would be a ware part. And the ubolts are longer on the 4x4...
  22. Replies
    10
    Views
    2,394

    It sounds like you have the fuel filter lines on...

    It sounds like you have the fuel filter lines on the input and return reversed.
  23. Replies
    1
    Views
    3,550

    the best sas swap is the ford axle if you are...

    the best sas swap is the ford axle if you are going leaf sprung. check out sas chevy on face book.
  24. Replies
    1
    Views
    817

    After i did that swap the trans didn't last very...

    After i did that swap the trans didn't last very long. I burnt the band at least 4 times before i swapped in the 4l80e and when it goes all your left with is 1st gear. The torque converter never gave...
  25. 2003 chevy silve. 6.0l engine with gt2-3 cam and zo6 comp springs slit bumb in idle.

    He guys so I had a 2003 denali 6.0 lq4 complete remand done with a few modes. first valve job with zo6 beehive comp valve springs and push rods, gmpp high out oil pump, comp timing chain, zo6...
Results 1 to 25 of 54
Page 1 of 3 1 2 3