Search:

Type: Posts; User: PitchBlackC3

Page 1 of 5 1 2 3 4

Search: Search took 0.05 seconds.

  1. All the iron head LQ4s had the long crank and...

    All the iron head LQ4s had the long crank and they all had the 4L80e (if auto) from the factory.
  2. Replies
    2
    Views
    600

    Replied

    Replied
  3. Replies
    47
    Views
    6,232

    What ever happened with this thing?

    What ever happened with this thing?
  4. Replies
    7
    Views
    1,614

    No, the 03+ stuff uses BCMs in the doors that...

    No, the 03+ stuff uses BCMs in the doors that communicate with each other and the other BCM thru serial data.
  5. Replies
    7
    Views
    1,614

    You can wire up the blinkers and power fold. You...

    You can wire up the blinkers and power fold. You will create tons of problems trying to use the newer electronics with the 99-02 truck.
  6. Replies
    2
    Views
    600

    WTB: 8.625" G80 carrier

    I have a rear with a cracked G80 case. Need one to replace it, let me know what you have.
    Thanks!
  7. Replies
    8
    Views
    3,595

    I've known people to cut them, but honestly it is...

    I've known people to cut them, but honestly it is easier to get a frame and swap everything over. Maybe you will get lucky and get the tank and drive-shaft and some lines with the frame.
    I'd just...
  8. Replies
    47
    Views
    6,232

    Are you getting any freeze data or a DTC set? ...

    Are you getting any freeze data or a DTC set?

    Sounds dumb, but check the fluid level while the message is flashing. Apparently fluid level problems can cause that message to set.
  9. Replies
    15
    Views
    1,467

    Frenchy is correct, anything 00-02 with traction...

    Frenchy is correct, anything 00-02 with traction control or AWD had DBW. It is a different DBW throttle body than the 03+ one. More related to the LS1 TB than the 03+.
  10. Replies
    165
    Views
    193,108

    None, it is purely mechanical.

    None, it is purely mechanical.
  11. If you were using a 99-02 PCM you could give the...

    If you were using a 99-02 PCM you could give the PCM control of the AC clutch circuit through a relay and use your HVAC controller to provide a request from the PCM.
    The 2005 PCM requires a serial...
  12. Replies
    20
    Views
    2,063

    DBW throttle bodies don't have idle air ports....

    DBW throttle bodies don't have idle air ports.
    It is the intake port for the crankcase vent. The older throttle bodies had the hole and then the nipple was on the intake that went to the valve...
  13. Replies
    7
    Views
    928

    Yep, I agree. My C3 had the SUV brakes on the...

    Yep, I agree. My C3 had the SUV brakes on the rear from the factory, I put the 05+ on the front, SS lines, and hydroboost with some hawk pads. Thing has some crazy brakes now.
  14. Replies
    7
    Views
    2,056

    My torrington sun-shell in my 4L65e stripped the...

    My torrington sun-shell in my 4L65e stripped the teeth off where it splines to the sun gear. Replaced it with a beast and no problems since. I'd upgrade while you have it apart. Relatively cheap...
  15. Replies
    7
    Views
    1,174

    Moisture causes the sensors to corrode. The...

    Moisture causes the sensors to corrode. The stock rubber boot doesn't adequately seal the hole they are in, water gets in and can't evaporate out.
    When you replace the sensors clean the holes...
  16. Check the lash on the rear end, check the front...

    Check the lash on the rear end, check the front CV shafts. Check ball joints and wheel bearings for play.
  17. Replies
    11
    Views
    2,216

    No it is not. It is a normal right handed...

    No it is not.
    It is a normal right handed thread, just like every other fastener on the truck.
  18. Replies
    14
    Views
    1,967

    You can use the resistor (not diode) method on...

    You can use the resistor (not diode) method on the trucks just like you can the older PASSLOCK I stuff. The only difference is the resistor is in the steering column rather than in the key like on...
  19. Replies
    102
    Views
    17,596

    That is a nice looking 68. I've been trying to...

    That is a nice looking 68. I've been trying to find a decent project 67-72 but nothing promising so far.
  20. Replies
    3
    Views
    878

    I think that is the LS1 injector part #.

    I think that is the LS1 injector part #.
  21. Replies
    7
    Views
    1,395

    Should be a M21 close ratio trans.

    Should be a M21 close ratio trans.
  22. Replies
    11
    Views
    6,855

    Yes, you can remove the oil pan with the engine...

    Yes, you can remove the oil pan with the engine in the truck. I had to lower the front diff before I could get my pan all the way off.
  23. Replies
    12
    Views
    4,063

    I have that same head unit. I need to get a back...

    I have that same head unit. I need to get a back up cam to go with it. Which camera are you using?
  24. Replies
    6
    Views
    1,022

    No, the 2500 and 1500HD have a 14 bolt...

    No, the 2500 and 1500HD have a 14 bolt semi-floater 9.5
    The 2500HD 6.0 has a 14 bolt full floater 10.5
    the 2500HD duramax has a 14 bolt full floater 11.5
  25. Replies
    17
    Views
    5,119

    Yes, you can use the 2011 5.3 intake with a...

    Yes, you can use the 2011 5.3 intake with a throttle body to match.
    No, you don't need an X-link. Even if your 2000 was DBW you wouldn't need it, it is for 03+.
    Yes you can use the 2011 fuel rail,...
Results 1 to 25 of 118
Page 1 of 5 1 2 3 4