A few years ago I bought a Rigid combo set. 18v drill and impact driver (before they came out with the new hyper lithium). The batteries lasted a couple years, but they are garbage now and expensive...
Type: Posts; User: Zukikev
A few years ago I bought a Rigid combo set. 18v drill and impact driver (before they came out with the new hyper lithium). The batteries lasted a couple years, but they are garbage now and expensive...
Hi all,
My truck specs are:
98 K2500, 03 LM7, rebuilt 4l80e from some 6L truck (do not know the year).
I finished the swap last spring and had driven the truck with very few issues up until a...
Bump to this.
I had so many issues with this truck running intermittently in this install. It turned out to be grounds. I read somewhere online that the ls engines are picky for grounds and that...
Got it all figured out.
There is a VSS extension that runs from the tranny to the tcase output that was still plugged in to 98 wiring. Plugged that in my speedo worked but my transmission still...
Well, truck runs and drives, FINALLY. What an arduous road.
The truck would go through phases where it would fire right up and run great, or not fire at all. I thought it was a pcm connection...
Very clean! Nice work
All the pins are straight and the bolts are tight. I wish they had made those with a bolt on either side. My next step is contact cleaner and dielectric silicone, but everything looks like it...
Starting circuit is good now. I missed a ground. Doh! :doh: Starter turns without issue now with the key.
Its just that if the fuel pump doesn't prime, I have to move around the wires going into...
I just put an LM7 into my 98 K2500. The swap is going fairly well, but I had a friend come over to delete the EGR, VATS, downstream o2 sensors etc. He said he couldn't see the pcm when he hooked up,...
Yeah sorry I mean C and N and they are both Ignition 3 voltage. I found an ignition 3 in my 1998 C100 (D8)? I was mostly curious what it actually is.
I think I have figured out why my temp gauge...
Thanks for the replies guys.
Engine is in and running. I haven't finished the wiring yet, and I'm also having some problems with the start circuit. Not sure what it is, but I think it might be the...
Thanks, I just saw that thread with pictures of the frame notch. I would rather go this route than do a relocation I think.
Regarding the Toy, thanks! My Toyota is partially finished. SAS, 5.29s,...
That notch looks better to me than shelling out $500 for relocation kits. Any idea why Nitrous' setup worked and yours didn't? Is there a little bit of wiggle room to raise the engine and maybe run a...
Update. Got my 6L flexplate, spacer and bolts. Got an 03 gas pedal. Got my harness modified at Nelson Performance. Got dirty dingo mounts.
I am likely going to notch my frame for the low...
Did you end up keep your lower passenger side AC mount? I think I am going to go this route. How did it work out?
EDIT sorry I see that you said you are running without AC right now. Do you know...
Hey everyone, I believe I have done a reasonable amount of research prior to posting, but I have some questions I'd like to clear up.
The 98 2500 I'm swapping into has a 5.7 and 4l80e.
Will I...