Well I'm running a pi 3200 10 1/2 single disk stall. At the line I brake and gas to stall it and at 1800-1900 rpm my slicks are spinning already any ideas on what I should do ? Or get?
Well I'm running a pi 3200 10 1/2 single disk stall. At the line I brake and gas to stall it and at 1800-1900 rpm my slicks are spinning already any ideas on what I should do ? Or get?
Rompiendo Culos Al 100
LS3+150 Shot N2o
Try to leave by only pullin the slack outta the driveline by barely bronging rpms up... Sounds like its just an extremely tight stall... I know my 3400-3600 actually seems to pull harder just barely rev'ing it to like 1400 to insure the slacks out and nail it!!!
Get u a circle d 3800 stall or bigger slicks , lower psi
That too lolOriginally Posted by CHEVROLADE
I'm running 28x10.5 R15 slicks at 13psi even at 9-10 psi it still does it
Rompiendo Culos Al 100
LS3+150 Shot N2o
I was told to go with a 9 1/2 size stall for it to be loss
Rompiendo Culos Al 100
LS3+150 Shot N2o
damm it depends on the engine torque output too but id get a bigger stall for sure
418trq
Rompiendo Culos Al 100
LS3+150 Shot N2o
damm thats some good torque ...yea u gonna need atleast a 36-4000 stall triple disc pa romper mas culos
How big is the cam? I bet you have a tight stall and very little vacuum. You're pushing through the brakes because they can't hold it with no vac.
1969 Chevy RCLB C10 350/TH400 SOLD
2007 Chevy RCSB 4.8 4x4 LS SOLD
2008 Chevy RCSB 5.3 4x4 LT SOLD
2010 Chevy CCSB 6.2 4x4 LT SOLD
2005 GMC CCLB DRW 6.6 Duramax 4x4 191,000 and counting
2013 FORD CCSB F350 6.7 Powerstroke 4x4
Posting Permissions
Reply With Quote
