Dynatechs come uncoated but made out of good stainless and 2.5" collectors. The collectors were cut short to weld on 3" collectors and then ceramic coated to do away with the heat build-up under the hood that is typical of SS and uncoated headers. The ceramic coating job covers the headers very well and thick but there are a couple of drips but nothing bad, only one is really visible when they are installed. These headers have 3K miles on them after being coated. These headers are in really good condition no dings at all just a couple of scratches from removal. Im asking 600+shipping for them since they go for 900 plus 300 for coating.
http://i23.photobucket.com/albums/b3...1/IMG_0690.jpg
Scratch where the heatshield was rubbing on it before I fixed the heat shield not noticeable when installed since it faces the firewall mostly and down kinda low
http://i23.photobucket.com/albums/b3...1/IMG_0691.jpg
http://i23.photobucket.com/albums/b3...1/IMG_0692.jpg
Dynatech emblem
http://i23.photobucket.com/albums/b3...1/IMG_0693.jpg
Couple of the install/remvoal "scratches" that would probably polish out Im just lazy
http://i23.photobucket.com/albums/b3...1/IMG_0694.jpg
The main drip that is noticeable when installed but isnt very bad at all IMO
http://i23.photobucket.com/albums/b3...1/IMG_0696.jpg
No low ball offers please, these are well worth the money. Im getting rid of them because Im putting an STS kit on my truck and the gains from these headers are very minimal with the backpressure created by a turbo.
