Purchasing a high mile truck = pros/cons

Printable View

08-14-2013, 02:42 PM
Tig

Purchasing a high mile truck = pros/cons

What are the risks of purchasing a high mile LS based truck/suv?
I've heard mixed emotions and honestly I'm not too concerned because I did most of the work to my previous OBS Tahoe and have read and heard the NBS' are easier to work on and maintain. My wife is concerned about it having high miles and the problems that may arise.

I'm looking for another suv, either a Tahoe or Suburban and my budget is well, lacking. The least amount spent the better right now, my oldest has just been moved into college and my funds are rather low.

I found a 03 Suburban w/245k miles, one owner no accidents clean car fax, something that seems to be rare these days. Another thing, it seems to completely stock. Which is also a bonus.

Any advise/info would be much appreciated.
Thanks
08-14-2013, 05:30 PM
GMCwantsLS1

If you are getting it for a good price go for it. Stock setups can go that mileage without too many issues. If you can fix one I would say no problem as parts are everywhere. Think of it as recycling! LOL!
08-14-2013, 07:30 PM
farmtruc

I say do it if you an do all the labor yourself.

With that many miles that SUV should be worth very little; don't get me wrong that is great for ppl like us.
Get the price down as far as possible and then go spend about a grand if u can on maintenance parts.
O2's. fuel pump. Brakes. Hoses. Bushings. Steering. Shocks. Worn out interior pieces like buttons. Etc and you'll have a good truck!
08-17-2013, 09:20 AM
Botlfed

Pros-cheap cons-you gotta work on it
08-17-2013, 05:48 PM
Tig

Quote:

Originally Posted by GMCwantsLS1

If you are getting it for a good price go for it. Stock setups can go that mileage without too many issues. If you can fix one I would say no problem as parts are everywhere. Think of it as recycling! LOL!

Well, the price is under $4k. That seems pretty reasonable to me. Hah, that's a good way of thinking of it.

Quote:

Originally Posted by farmtruc

I say do it if you an do all the labor yourself.

With that many miles that SUV should be worth very little; don't get me wrong that is great for ppl like us.
Get the price down as far as possible and then go spend about a grand if u can on maintenance parts.
O2's. fuel pump. Brakes. Hoses. Bushings. Steering. Shocks. Worn out interior pieces like buttons. Etc and you'll have a good truck!

Pulling the motor and dropping the tranny can be done at my buddies shop, everything else can be done at my house.
The one thing that concerns me is "when" it will happen and being prepared for it.
That is my plan, preventative maintenance, get it all done before anything happens.

Quote:

Originally Posted by Botlfed

Pros-cheap cons-you gotta work on it

Both very true.

Thanks guys, I appreciate your info
08-17-2013, 08:21 PM
bootlife

A friend of mine just picked up a loaded 2000 suburban for 2500 has 230,000 on it
08-17-2013, 08:21 PM
kerrige

The when is a total roll of the dice. These motors are known to run for 300k+ however the valve train is notorious for random failure. Bent pushrods, collapsed lifters, loose or failed timing chains and rockers losing needle bearings are common in these motors at any age. The bottom end on the other hand likely will never need to be touched. The trans is a time bomb ready to explode from the day it rolls of the factory assembly line. Some will last 15k others 150k. I would plan on an 80e swap as soon as funds will allow. The stock posi G80 or known as the grenade 80 is also a known weak point. The fuel pump may likely need to be replaced. That is a good starting point. IMO 4k is a good price and with proper care and maintaince could be a bad ass ride for many years to come.
08-18-2013, 08:06 AM
Tig

Quote:

Originally Posted by bootlife

A friend of mine just picked up a loaded 2000 suburban for 2500 has 230,000 on it

Nice, that is another option. I had found an 01 with 185k miles for $6900. Its a bit more than I wanted to spend but you get the 6.0, 4l80e and 14 bolt rear. It may be worth it in the end and its 2wd.

Quote:

Originally Posted by kerrige

The when is a total roll of the dice. These motors are known to run for 300k+ however the valve train is notorious for random failure. Bent pushrods, collapsed lifters, loose or failed timing chains and rockers losing needle bearings are common in these motors at any age. The bottom end on the other hand likely will never need to be touched. The trans is a time bomb ready to explode from the day it rolls of the factory assembly line. Some will last 15k others 150k. I would plan on an 80e swap as soon as funds will allow. The stock posi G80 or known as the grenade 80 is also a known weak point. The fuel pump may likely need to be replaced. That is a good starting point. IMO 4k is a good price and with proper care and maintaince could be a bad ass ride for many years to come.

I have read so much about these motors being abused and lasting hundreds of thousands of miles without issue. Its the tranny I am more worried about than anything.
That is when the 01 HD Yukon XL comes into play. Is it worth the extra cash for the added power stronger tranny and bigger rear end? Also, the gearing, 4:10s aren't so pleasant for daily use. I'm thinking about swapping them out for 3:73s, if I go that route.

Thanks for the info guys
I'm thinking swap to 3:73s and be done with it
08-18-2013, 12:22 PM
kerrige

4.10s are actually great especially in that big freaking pig. I would say the 80e and stronger rear are defiantly worth it. Think about it this way 4k vs 6900 is 2900 of difference. The cost of a 6.0, trans and rear swap will be a lot more than 3k after odds and ends.
08-18-2013, 07:10 PM
Tig

Are there any chassis differences between the HD Sub/Yuk XL and a standard Sub/Yuk XL?
I agree, with the 6.0, 80e and stronger rear, its definitely worth it.
08-23-2013, 07:25 PM
Tig

Going out this weekend to find a new to me Chevy.
08-26-2013, 07:28 PM
Tig

Yay
http://i804.photobucket.com/albums/y...ps12ce88e5.jpg
http://i804.photobucket.com/albums/y...psf790f8ea.jpg
08-26-2013, 08:21 PM
conekiller01

How much did you give for that? I'm hoping to do something similar in the next couple months it's pretty sharp I like the police wheels
08-26-2013, 08:26 PM
GMCwantsLS1

cool deal! That looks like a steel! Get it tuned and run the hell out of it!
08-27-2013, 11:30 AM
Chevy-Art

Nice, and it looks like a law enforcment vehicle. I like the roof rack delete. And it needs better lights.
08-27-2013, 02:24 PM
Tig

Quote:

Originally Posted by conekiller01

How much did you give for that? I'm hoping to do something similar in the next couple months it's pretty sharp I like the police wheels

It was listed for $9900 but, I got it for a little less than asking ;)
You know, you cant beat them. Where else can you get a complete history of maintenance on a used vehicle. Me to, I was looking at the Soft 8s for my other Tahoe.

Quote:

Originally Posted by GMCwantsLS1

cool deal! That looks like a steel! Get it tuned and run the hell out of it!

Thanks man. It certainly was. That's going to be my future plans. Right now, I'm just going to enjoy it, hah.

Quote:

Originally Posted by Chevy-Art

Nice, and it looks like a law enforcment vehicle. I like the roof rack delete. And it needs better lights.

Thanks
Me to, it really cleans it up.
It's a retired State Police vehicle/PPV.
Yeah, I need to polish out the head lamps.
08-28-2013, 11:05 AM
Chevy-Art

Is there a place or auction you went to to buy it?
08-28-2013, 05:09 PM
Tig

Quote:

Originally Posted by Chevy-Art

Is there a place or auction you went to to buy it?

The State Police sell there cars through the State Surplus.
The State Surplus also has auctions for repo vehicles as well.
08-30-2013, 08:11 PM
Mr Sir

I bought my 2002 5.3 Silverado with 240k for 1100. Using it as a drag truck, currently rebuilding the 4L60E and I'm just going to hope it holds all the power I plan to put down.