Printable View
is something wrong with my motor mount adaptors? got bored and mounted them and noticed mine fit differently than all the examples ive seen online. the pointed part on mine is on the bottom, cannot switch sides or they hit the mounting bracket directly above. what gives? (ignore the bit broke off in the allen bolt)
Attachment 4468
LOL, it's upside down. :laugh:
soooo.... pointed part towards the back? i thought i read it goes towards the front.
Pointed end goes up and toward the front of the engine.
hmm, the pointed end cannot go up or it hits a mounting bracket on the block. its obvious which side faces out due the bolt hole recesses. ill take em off and try to figure it out.
shorten the bracket
yup, gonna hav to trim both corners down. can anyone verify these are the correct -1 plates i should be using
they are on the wrong side of the block. the 2 bolt holes go
at the top of the motor not the bottom.
so did you get the plates to work or not?
had to cut both top corners off, appears to be ok. ill find out for sure when i put the motor in.
that can't be good, it looks like you have the plates backwards.
I had to trim the corners of my plates too
the 2 bolts are suppose to be at the top. i never had to trim mine...they went in perfect. i did have to notch the clam shell mount though