Hbeam rods, pins, and TBs

I have some things left over from my 370 build.
1st up is some forged H-beam rods. They are 6.1 the length is stock and it takes a .927 pin. My engine builder said they look like skat but are more than likely Pro Comp. HE also said they should be good for the same HP rating as eagle or skat. Price is $300.00 + shipping
http://i83.photobucket.com/albums/j3...ey79/Rods2.jpg
http://i83.photobucket.com/albums/j3...ey79/Rods1.jpg
http://i83.photobucket.com/albums/j3...ey79/Rods3.jpg
http://i83.photobucket.com/albums/j3...ey79/Rods4.jpg

Next is the wrist pins that came with my Mahle pistons. They are .927
Price is $30.00 + shipping
http://i83.photobucket.com/albums/j3...27pins1jpg.jpg
http://i83.photobucket.com/albums/j3...27pins2jpg.jpg
Next is 2 3bolt truck DBW TB's. One has been ported and polished. The P&P'ed one as a crack on the plastic cover for the blade motor and gears. It can be replaced with your current one just by drilling out the rivets and putting 4 small bolts in their place.
TBs Stock $30 + shipping

P&P TB $50 + shipping.
http://i83.photobucket.com/albums/j3...iley79/tb6.jpg
http://i83.photobucket.com/albums/j3...iley79/TB4.jpg
http://i83.photobucket.com/albums/j3...iley79/TB2.jpg
http://i83.photobucket.com/albums/j3...iley79/TB1.jpg

Those Rods are Procomp, (I can tell by the bolt #'s) and are good to 800hp. Procomp supplys Probe with H-Beam rods for their kits. Just a FYI I get them all the time and never had a problem.

Thanks for the info.

BUmp up top

All 78mm TBs?

Yup sure are. I should have but that in the 1st post

I just saw that you said 3 bolt. I should have known. Unfortunately, I'm looking for a spare 90.

Buy my stuff or i will be forced to build the fasted 5.3 ever.

I wish that ported TB was DBC. :(

Ya it would have been on your truck already.

True story. Maybe I will get a spare and send it off to you.