Printable View
are the cam bearings from the genIII motors different from the genIV?? i recently got my engine back from the shop and they installed clevite part# SH1995s
by comparing em the factory cam bearings are a little wider and the oiler holes are bigger...:rolly: and thats cause there installed already......i know aftermarket will always be different from factory but rather be safe than sorry again ...so any one ?according to the shop thats what it called for.....
i'll check today at work if no one else knows. Should be home in 6 hours, working short shift today lol
cool man thanks
ttt...........
I searched for awhile with no luck.
So.......
1. How do the cam bearings look in the block? Do they look like they need to be wider?
2. Stock cam?
3. With the cam out, do the old bearings over lap the journals?
I will keep looking though.
yea they look like they need to be wider..but thats what it called for?...then 2.this engine did have the VVT cam so who knows lol,,just hope i dont run into problems at start up......heres some pics
about a 1/4 inch shorter
http://i244.photobucket.com/albums/g...e1/zzzz037.jpg
check out the difference from the stock bearing,also notice the oile hole size difference.but maybe thats cuz the vvt cam?
http://i244.photobucket.com/albums/g...e1/zzzz038.jpg
i was thinking on calling and asking HKE in houston,but really dont like to bother who i havent done buisness with.
They changed sizes in 05. So basically everything GEN III and GENIV use the same bearings from 05 to now...
The width didnt change only the OD. If it were mine I would put another brand in other than clevite. That is a tiny oil hole...
my situation with this damm motor has been nothing but trouble.....sucks............should just sell it lol
Here are some ACL parts numbers. this shows the difference.. It was 03 that they changed not 05 my bad!!!!
Take a pick and push it through the oil holes and make sure they are lined up with the gallies. Looks questionable from the pic!!!
* 5C1000S suits engines from 1997-2003 with 1st design # 1 & 5 housing size of 2.3260"-2.3280".
** 5C1001S suits engines from 2003 on with 2nd design # 1 & 5 housing size of 2.3460"-2.3480".
thanks for that info.........i will try that right now........
glad u are helping me jon,,,ok one question,these oil gallies are they only on the right side of the engine?like one gallie to each lobe?they did not align the 3rd bearing good:( all the rest the coat hanger goes through but the 3rd bearing!!i can see right through and that 3rd one is a little off....why dont these damm shops check this kind of shit before they let it go!
No problem... Yes they are only on the Pass side. If the middle one is off that bad then you are going to have serious issues with oiling.. I would get them to fix it before you do anything else.
just seen this tool,probably couldve done a better job if this tool aint hard to use
http://carshop.carshopinc.com/produc.../103019/c/s1-l
guess back to the machine shop:(