Printable View
it out of an 07 Chevy it had a valve spring problem an dropped a valve. it kissed the piston NOT THE CYLINDER WALL!!!
no cam/no lifters/no front cover but will come with oil pan, rear cover, rototating assembly any sensors left in the block.
i can have pics up tonight.
250.00 i will not ship an ill drive 2hr from Baton Rouge, LA for 60.00
so it needs a new piston?how many miles?
yes sir, 42xxx before his 6.2 swap
ill wait for pics bro
you can still see the cross hairs in the cylinder walls
http://i33.photobucket.com/albums/d8...f/ef711ba4.jpg
http://i33.photobucket.com/albums/d8...f/debe7bc6.jpg
http://i33.photobucket.com/albums/d8...f/907fd5f2.jpg
http://i33.photobucket.com/albums/d8...f/ed8b1afb.jpg
if need be ill get better pics of the cylinder wall but theres no scare/scratch in that cylinder just the piston was harmed!
probly dumb question but will a 4.8 piston work in there?
honestly i cant answer that does your pistons look like mine? Flat tops
have no idea lol,maybe ill ask redheartbeat
i also have a Futral cam
224/228 .588.576 112+4 has 6500 miles on it at the most 320 shipped obo pics of it tomorrow when i wake up an pull it
I've heard they're the same pistons used in the 4.8 and 5.3 engines. The trick is getting the right weight piston so the engine is still balanced. Most all GM pistons are supposed to be the same weight within a couple grams. You can buy one complete rod assembly from GM with the rings already hung and ready to install. :thumb:
sweet i didnt know that!
an your 4.8 stuff will swap right over too :)
i need this gone so i can do an LSx swap in an S10 with my 5.3 out of my CC :)
hey ken did he ever run it with that piston like that?that the reason he swapped it?
no he swapped cams, it was a .588 cam, he had single valve springs an it broke at idle. good thing he heard a noise as it broke an shut the truck off. it broke on its compression stroke at almost TDC so it didnt touch the cyl wall.
he pulled the valve covers an seen the valve dropped so he pulled the engine an sold the heads an bought his 6.2
i used my cell phone for the pics but ill get better pics with my digi camera an get them up.
Factory rotator parts are supposed to be ''0'' ballance, so you don't need to have it blueprinted. The L92 I bought from Keith was in the same exact condition, one piston nicked up from a hanging valve or something. I thought it might have been because of VVT. Either way, I bought one new L92 piston, and will be putting it together with the rest of the rotator. Shouldn't be any problems with it.
sweet see there ya go, 1 piston an the time to pull it and your good to go.
does a 99-02 crank fit these blocks? if so i may just swap cranks an run it in my fiance's camaro if it doesnt sell soon
i have a 5.3L that had the exact same problem with a bad batch of 918 single springs and a 220/222 581/581 114lsa cam
i paid 300 for the longlbock and the cam