Project EFI to Carb in my 2007 Silverado

Well, I've decided to do something a little bit different from the normal this next year on my truck. Most people will say "what a dumb idea" blah blah blah, but I'm going to take a bit of an old school approach at going fast next year.

The parts list I have worked up so far is:
Quickfuel 950cfm e85 Carb
MSD 6LS Ignition
20gallon Aluminum Fuel cell
Holley Billet 150 fuel pump w/12-803 regulator
Push lock fuel line

Still trying to figure out which throttle pedal to use and which/how long of throttle cable I need to buy. Thinking prolly just a 99-02 silverado pedal and some kind of Lokar cable. Any suggestions are appreciated. Thanks

First little bit of this project showed up today!
http://i220.photobucket.com/albums/d...t/687520CE.jpg
http://i220.photobucket.com/albums/d...t/D3482F88.jpg

Right on Danny, I think it will be pretty sick my self man. I mean who can fault you for doing something different. :rock:

That's like selling your flat screen and buying a old floor model..... Jk. It's definitely different and should be interesting too. Good luck with the build. And the first thing I thought of when I saw your carb was a leprechaun.

im excited to see the results.... :hyper2::hyper2:

Nice project, you might want to go with a bigger cell.. You will wish you had those 5 or 6 extra gallons.

Going to be badass

racetruck

Just thought of a possible obstacle. Since I'll be doing away with factory PCM, how will I start my truck? I had to hook my park neutral switch up before it would run when I put the new trans in

Basically I don't know if the pcm tells the bcm anything that will cause troubles once the pcm is gone. Thanks

Could always resort back to non-databus wiring aka 99-02