ASP pulley kit, Gen III maybe IV too

You still got one? PM me you paypal info..Im bought to go to the bank and deposit some cash for it...
Please hold for me! Ill pay you whenever I get your paypal address. Thanks!

Got your payment, it's going out tomorrow

:)yeeepp....

whats the best thing to use for lubrication when putting this on?

put it on dry.

Quote:

---

Originally Posted by RedHeartbeat

put it on dry.

---

really? the note in the box says to lubricate it.. but you probably know more then the note lol

I always put them on dry. I warm the center up with a propane torch and then slide it on as far as possible. Don't melt it, just warm it up so it will fit over the crank.

Quote:

---

Originally Posted by RedHeartbeat

I always put them on dry. I warm the center up with a propane torch and then slide it on as far as possible. Don't melt it, just warm it up so it will fit over the crank.

---

okay ill do that thanks greg

Yeah, use a propane torch--but heat it for like 3-4 minutes, evenly distributing the heat around the inside bore. After about 3 minutes of heat time, quickly shove it on the snout of the crank--it should go on about 3/4 of an inch or so. It only needs to go on about 4 full turns of the crank bolt. You need about 4 full thread turns on the crank bolt to insure you seat the pulley correctly.

put me on the list for when you get some more!

Thanks,
Chad