Josh Power's AC bracket

Sorry guy's I was unable to make it to the shop tonight, look's like it will be Saturday before I am out there again, but I will get some pics.

yall can see the last page of my build i have a couple pics of my josh powers brackets. i had to trim down the tensioner mount on my water pump, did you have to do that?
i also have a goofy compressor with tabs where the bolts go so the bolts werent long enough so i upgraded to a 10x1.5mm 4" long

ok so these work with truck accessories or not? im in louisisana and its starting to get a little warm around here

yes it works with the truck ACCs i live in gramercy, where do you live?

on my truck water pump i had to trim down the tensioner tab to allow the bracket to fit. i also swapped out to a 10x1.5mm bolt 4" longto hold my compressor to the bracket(mines weird it has tabs on it.) i also had to swap the flat pulley out to my stock tensioner pulley bc the one that came in the kit was too wide and would allow the belt to walk and itd jump a groove on the AC compressor. but my ALT pulley is bent i think so imma change it out and see. but im using a 1080k6 (its tight) with a stock crank pulley, no slip either.

go look in my build thread last page i have a video of it and when i get he tomorrow ill upload the new video of when the belt jumps a groove and starts whining lol

im up here in shreveport

hey now-

I am sure there are lots of guys proud to show their A/C conversion brackets from Josh Powers. Dig out those old photos and post away. We reached 90F yesterday and A/C is required to be COOL...

thanks,

ZRod

if you look in the last 2 pages of my thread you'll see the kit mounted, and you can watch the video of it.

i can get more since i swapped the tensioner, pulley to work the way i wanted it.

Any body know how to reach him? I sent a PM but haven't heard back.

superpowers1980@yahoo.com

My 6.0 motor is installed- Started on the wiring for gauges, transfer case, etc. Will be installing the 6.0 wiring harness this weekend... need a/c down here in South Texas.

Any users of Josh's bracket remember what/ how to fit Vortec engine accessories? Pictures would be great?

Thanks Guys,

Z-Rod