my first ls swap 1996 2 door Tahoe 4wd 385 Stroker to LQ4 cam headers **pics**

Quote:

---

Originally Posted by HPICamaroSS

Ya that drivers firewall connector controls most of the front lights so if that doesnt work I would say you have a ground problem. Because mine were acting funny, i fixed a few grounds and everything is 100% now. But I didnt have any issues like yours.

---

plugged it up and worked great! thanks bro!

new CAI installed...

http://i1105.photobucket.com/albums/...y/IMAG0816.jpg

http://i1105.photobucket.com/albums/...y/IMAG0817.jpg

fit perfectly! just gotta change out the ugly blue couplers for red or black ones. i fired it up today and got the tach working...just gotta hook up the efans and get the exhaust ran. and shes done! finally....geez it only took 39 pages lol

did you have to put in any type of resistor for the tach? if so, what did you use?

Quote:

---

Originally Posted by RPM Graphics

did you have to put in any type of resistor for the tach? if so, what did you use?

---

X2....my tach seems way off too. Its seems way too low?

i used a 680 ohm 1k resistor. works perfectly now.

Quote:

---

Originally Posted by myzterray

i used a 680 ohm 1k resistor. works perfectly now.

---

Is that what your tach was doing too? Seemed way too low? It sounds like I can rev the piss out of mine and I can only hit around 2500 lol.

Quote:

---

Originally Posted by HPICamaroSS

Is that what your tach was doing too? Seemed way too low? It sounds like I can rev the piss out of mine and I can only hit around 2500 lol.

---

yea mine wasnt working at all. now it works perfectly.

installed my efans today..

http://i1105.photobucket.com/albums/...y/IMAG0821.jpg

http://i1105.photobucket.com/albums/...y/IMAG0822.jpg

so after talking with Redheartbeat he help me diagnose my trans issue. the 2-3 solenoid was either blown or not getting any power. so i dropped the pan today and bench tested the solenoid. it was good. checked the wiring and there was a break somewhere. after going through the entire harness i find this!

kinda hard to see the the blk/yel wire is disconected. i hooked it back up and voila! we have power! so i figure now i dropped the pan ill change the filter and fluid. also clean up the pan.

http://i1105.photobucket.com/albums/...y/IMAG0825.jpg

http://i1105.photobucket.com/albums/...y/IMAG0826.jpg

http://i1105.photobucket.com/albums/...y/IMAG0827.jpg

sweetness! getting closer to making that trip to GA!

Great to hear the trans got fixed man!