How much did you shorten the drive on T56 swap?

Quote:

---

Originally posted by LS1Nica@Aug 21 2005, 01:42 PM
Hey I swapped a LS1/T56 combo into my 1500 and I reused the stock driveshaft. But I still only have a 10 bolt rear, but it sounds like Red has got you covered. Good luck with it.

---

i also re-used the stock length one, a word of advice, change your u joints while its out.....or just make sure they're good.

Quote:

---

Originally posted by Sleeper@Aug 26 2005, 07:49 PM
a word of advice, change your u joints while its out.....or just make sure they're good.

---

Good advise! I did not do this and I think 6 gear tore up his drive shaft after the 4.56 gear, right? I might need to get under there and check them out.