Hptuners Log data translation help required !

Just email Allen !

Quote:

---

Originally Posted by CHEVROLADE

Just email Allen !

---

<br />
<br />


I rather email Casey than Nelson....

I'll figure it my way :'(

is youre trans revolutions correct? the trans will not shift correctly if these tables are not in order.

if yoru tables were setup for a certain size tire then you change the tire without changing these tables then it will not match actual

for a simple test zero out either the mph table or the RPM table and go off the other. set the table to a value you know is safe for now and raise it slowly till it reaches desired. also take into account the amount of shift time delay is being used. so you may need to command a rpm or mph slightly before actual

Quote:

---

Originally Posted by George C

is youre trans revolutions correct? the trans will not shift correctly if these tables are not in order.<br />
<br />
if yoru tables were setup for a certain size tire then you change the tire without changing these tables then it will not match actual<br />
<br />
for a simple test zero out either the mph table or the RPM table and go off the other. set the table to a value you know is safe for now and raise it slowly till it reaches desired. also take into account the amount of shift time delay is being used. so you may need to command a rpm or mph slightly before actual

---

<br />
<br />


It appears that my segment swap is changing gears based on speed and not rpm as usual.


Talked to Allen Nelson and he founded out, and talked to Bill@hptuners and it appears to be some glitch in the matrix......

I can swap ecm and put new credits or....tune based on mph.


it happens once every million years to a dork. ..this time it choses me.


Thanks guys for all the help

Gth

ladies first !, after u......