per mahleQuote:
Originally Posted by ChevyLee
3.905 x .005
Top ..020
2nd .022
I am think of .022 and .024
Printable View
per mahleQuote:
Originally Posted by ChevyLee
3.905 x .005
Top ..020
2nd .022
I am think of .022 and .024
Are you not going to do any type of power adder like boost or spray?
Spray a 150 to 200 shot two stageQuote:
Originally Posted by ChevyLee
Today i mocked up the DRods fuel cell into my 2dr Tahoe .. I pick this cell from TxStVanWilder Friday and it fit great.. Here what left to do so the fuel cell fit the way I need to ..
Cut about 2 3/4 off the back side of the mounting tab
Add some rubber cushion between the frame and cell mounting tabs.. Should lowwer the cell about 3/4 of an inch
http://i136.photobucket.com/albums/q...h_b174df83.jpg
http://i136.photobucket.com/albums/q...h_05b4e932.jpg
http://i136.photobucket.com/albums/q...h_54081209.jpg
Here where I am at on the motor rebuilded. For the stall I went with a revmaxx 2600 stall.. I figure use the lt 4l60e and a stall untill it blow and then go with a 4l80e
http://i136.photobucket.com/albums/q...h_946331a1.jpg
http://i136.photobucket.com/albums/q...h_57d30bd2.jpg
http://i136.photobucket.com/albums/q...eet/th_007.jpg
Ok finally had time to work on the Tahoe .
Cut the floor and made room for the drive shaft
http://i136.photobucket.com/albums/q...t/0c3f3c0c.jpg
http://i136.photobucket.com/albums/q...t/8873dc3f.jpg
Drilled and tapped the the head for a mech temp gauge.
http://i136.photobucket.com/albums/q...t/6a78c926.jpg
You see in the next two photo how much the rear was narrowed .
http://i136.photobucket.com/albums/q...t/72182d34.jpg
http://i136.photobucket.com/albums/q...t/67d51e2f.jpg
http://i136.photobucket.com/albums/q...t/01015641.jpg
Some new parts showed up today
http://i136.photobucket.com/albums/q...t/02d736e4.jpg
nice!!! i need to get a couple of those Viair's, since i lost my engine driven.
Thank u
They are price fair too. I paid $220.00 for both 444c comps
any updates on this build?