TrueTrac Problems

No, not so much. They can have a side bearing preload out of spec or a crush sleeve not done exactly right....lots of other things too like pinion depth, rotating torque, pattern off....all of which could cause a noise that would never make it fly apart.

Quote:

---

Originally Posted by LamboDoNoMo

mine were installed properly if not pretty sure they woulda went kaboom, sometimes i get irritated by the crap that spews outta people.

---

I try not to look at peoples crap, especially when its spewing...:LOL:

Well i took it to him today and go it back this afternoon he said he adjusted backlash and put on a new pinion bearing. I drove it for a while this afternoon and no noise at all i was very glad!!! I was bout ready to ring his neck!

good news, glad it is fixed

Quote:

---

Originally Posted by LamboDoNoMo

mine were installed properly if not pretty sure they woulda went kaboom, sometimes i get irritated by the crap that spews outta people.

---

My only point is that sometimes people think that just because they go with a different, heavier, stronger or aftermarket gear that it is supposed to make a little noise. Then they end up driving around for a little while and it goes boom. Glad yours is working out for you G and glad the OP got theirs fixed.

Quote:

---

Originally Posted by ramair2002

My only point is that sometimes people think that just because they go with a different, heavier, stronger or aftermarket gear that it is supposed to make a little noise. Then they end up driving around for a little while and it goes boom. Glad yours is working out for you G and glad the OP got theirs fixed.

---

+1

+2

+ ead :lol:

:tvhaha: ^^^^

:popcorn: