Is there any negative effects for over sizing the line?Quote:
Originally Posted by RedHeartbeat
Printable View
Is there any negative effects for over sizing the line?Quote:
Originally Posted by RedHeartbeat
Cost of bigger line and fittings, takes more fuel to fill it before it hits the fuel rail.
Ok well i Got the Headers in from S&P.
http://i65.photobucket.com/albums/h2...d/DSC_0514.jpg
So i test fit them and trimmed the transcase on both sides here. The driverside needed more taken off than the passanger side.
http://i65.photobucket.com/albums/h2...d/DSC_0505.jpg
http://i65.photobucket.com/albums/h2...d/DSC_0509.jpg
dont mind the dog tail
I also got some new Polyurathane inserts so i replaced the old rubber mounts.
http://i65.photobucket.com/albums/h2...d/DSC_0506.jpg
The engine went in fine but as im aligning the motor mounts it seem that they are off about 1". Looking at the picture i can see now that the poly mount looks wider. But im going to get some new rubber ones and see if it will fix the problem.
So here is how she sits so far.
http://i65.photobucket.com/albums/h2...d/DSC_0559.jpg
I also recieved the Wireing harness and ECU back from NealsonPerformance (quick and good service i might add). With the let down of the mounts i opted not to start on it though.
man thats gonna be a nice ride when done, know sence in rushing it!! good luck on completion
Nice truck how are those header and how much $$$$
like this i wanna put a 5.3 in my 84 soon
They are real nice. Around 500 from S&PQuote:
Originally Posted by turbo.trex
Well alittle update, since last year. I placed the engine and transmission, had a driveshaft made, Dropped the druck 6/6 installed all the accesories, plumbed the trans/fuel/oil/radiator lines. Wired and ready to go..... or so i thought.
The engine will crank over but will not stay running. Is there anything in peticular that i need to look for, or that i overlooked?
Here are a few latest pics i have at work.
http://i65.photobucket.com/albums/h2...2-30-09002.jpg
http://i65.photobucket.com/albums/h2...2-30-09008.jpg
I actually have the bed and front end put back on now.
Sounds like you did not have the VATS turned off in the PCM.
I can call and check but i mentioned that to Nelson Performance which did the ECU.Quote:
Originally Posted by RedHeartbeat