how was bleeding your slave? any suggestions how you did it?
Printable View
how was bleeding your slave? any suggestions how you did it?
n/m BSridenguy i got it.....moved stock x-member back a set of holes and used the stock trans mount, had to put a little notch in the x-member but the 56 fits perfectly!
Well over a year and a half since the last post, but still great info.
Thanks for all the posted documentation.
So the original master cylinder works with the t56 slave? Or was a swap to a different bore/stroke necessary?
Been looking for a T56 but not in a rush, the NV3500 is holding up good so far, only has about 3000km on the swap.