2-bar SD parts (2-bar MAP, IAT, breakout harness)
Going back to stock here. These were the parts I needed to go to a 2-bar SD setup.
2-Bar MAP - good for about 14psi on a 2-bar SD tune
Asking $50 shipped
http://www.ls1truck.com/forums/attac...6&d=1355529550
IAT sensor
Asking $20 shipped
http://www.ls1truck.com/forums/attac...7&d=1355529572
MAF/IAT breakout harness - plug and play to hook up an IAT sensor. This harness uses the MAF plug on the truck's wiring harness and splits into two seperate plugs - one for the MAF (can leave it unplugged if going SD) and one for the IAT shown above (needed if going SD).
Asking $25 shipped
http://www.ls1truck.com/forums/attac...2&d=1355529461
