Printable View
Got a set of long tube have no clue on the name Tub 5 and 7 rape around each other and getting plug wires around them is a night mare. Keep burning them up. Anybody got any tricks on what to do. I could run a very wire on each of them and go under and over but will the longer wires on just two plugs cause issue with timing?
You could try a little longer wire and use a heat shield bootie where it's close to the header.
if i could get the pic to upload from this computer, i took a short piece of very thin aluminum strap, bent it and popped a couple holes in it. bolts on using the header bolts, goes over the tube and holds the plug wires back. also acts as a shield.
My speed daddy lts has 5&7 the same way. Raised coil 5 and ran longer wire and #7 just looped wire behind block and under hedder with 90degree boot.
Thanks guys will get to it. Been out working on the Nova the Whipple 510 is making some good power. Just put Holley's new EFI setup on it. Hope to have it back running first of next week.