Printable View
Hey guys, I had a truck intake and tb given to me and I'm gonna try my luck at porting em... Is there any advice? I know I've heard of people cutting the intake apart and epoxying it back together after, where should this cut be made? And inside behind the throttle body there's like a tube that goes in, should I remove that tube completely or should I just smooth it up and maybe open up the holes more?
Im gonna tag this thread, no advice for you but im interested too
doing the same so interested in what will be said here
Wow.... Noone has done this? I know people have done this.... I can't seem to find much information online about it but that doesn't mean it's not out there.... U guys seen anything anywhere about it?
There's a good horsepower tv episode that shows some details on it. And look for jansens thread in the forsale section he just posted
if youre ever deciding on going forced induction of anykind, make sure to change back to a non modifies intake, on a side note i dont wouldnt think that porting a stock intake would be that benificial for the amount of work involved. But hey man more power to ya, good luck.
I read to quick, my last post was about heads. My bad