Printable View
i just put a 6 liter in a 93 dually and I am almost ready to fire it up.... waiting on harness from Current Performance. But i have 2 questions...
On top of the intake there is a sender/sensor that has a hard plastic line from it... can i cap that off?
Also the steam line from each head i can attach it to the overflow right?
Thanks for all the help i will get some pictures up when i get it running
The hard sensor with the hard line is the evap it can be plugged. I think
I have no idea about the steam line.
what skinny said, it can be capped off, also the steam ports concidering the use of the vechicle you can either cap all 4 corners or run the f body front line and cap the back or tie all 4 together and run it to the radiaitor. never seen it done to the coolant overflow tank but i have seen it tapped into the water pump
i am a little confused.... my 6 liter has a line on each head at the front then goes into the tb and then the line out...... i could be missing the rear ports but i have not noticed them beforeQuote:
Originally Posted by skeet
That's the coolant lines that go to the tb that your talking about?
iunno..... its got a steal line that joins the 2 heads then goes to the tb and then a small rad hose that i have no idea where it goes....i thought it was the steamQuote:
Originally Posted by skinny chicken
Mine has the same steel line that goes head to head. The driver side has an outlet that sends steam through tb, then on to radiator or water pumpQuote:
Originally Posted by unperfected
Check this thread out for the steam vent routing:
http://www.ls1truck.com/forums/lsx-t...t-routing.html
This link help to http://www.ls1truck.com/forums/lsx-t...team-vent.html
thanks everyone for ur help