Printable View
well i got a hold on a intake of a 2010 NNBS with 38 pound injectors and im going to slap it in my 05 but im wondering about the sensors that go on my current intake mainly the one thats towards the firewall my question is wat can i do about that sensor and will the injectors have the same connector as the ones i got on right now thanks in advance guys
.....
On the map sensor just pull the extra wire out of your loom. You have plenty. Then retape. Arnt the nnbs tb's 87mm 4 bolt? Your 05 is a 3 bolt. You will need other things to complete your swap unless you have it and didnt mention it.
The 38 # injectors most likely have different plugs. The EVAP solenoid is in a different location, but the plug is the same as well.
The injector plugs are different you will need a 4 bolt tb youll also need the x link adapter, oh and youll need a tune for the bigger injectors.
well i got a four bolt tb off a trailblazer ss so i think that will work, i will try that with the sensor just pull the wire, as far as the injectors i tryed one on and it clips on but i wanna make sure its the same connector
wat else can i try so that the injectors will work
Look up a ev1 to ev6 adapter i think that might be the adapter you need.If not maybe that will help guide you
If the injector plug is the same, you must have a FLEX fuel truck. If so, the new ones probably aren't any bigger.
well u got a good point becuz i do have a flex fuel truck, so the connectors are the same if so do u think its worth putting the injectors onQuote:
Originally Posted by PitchBlackC3