So this is probably a dumb question...

Printable View

11-14-2010, 09:39 PM
Slammed96

So this is probably a dumb question...

So the answer to this is prolly obvious and I just have failed to notice but where can I find pistons and rods for a 6.0? I'm gonna have to have it bored 30 over and it already needs three pistons and a rod. (dropped a valve) Pretty much I'm looking for a fairly cheap stock or close to stock setup for the bottom end. All help is greatly appreciated. :thanks:
11-14-2010, 09:55 PM
pl4yboy

Quote:

Originally Posted by Slammed96

So the answer to this is prolly obvious and I just have failed to notice but where can I find pistons and rods for a 6.0? I'm gonna have to have it bored 30 over and it already needs three pistons and a rod. (dropped a valve) Pretty much I'm looking for a fairly cheap stock or close to stock setup for the bottom end. All help is greatly appreciated. :thanks:

You will need a full set of custom pistons if you're having it bored 30 over. Stock pistons wont fit anymore. I believe Eagle makes the cheapest pistons you'd need.

I would get a good set of pistons, a good set of rods, and use your stock crank if I were you.
11-14-2010, 10:00 PM
sprayedenali

eagle doesnt make pistons...?
11-14-2010, 10:32 PM
RedHeartbeat

speed-pro and master engine products, IIRC. (enginetech.com)
11-15-2010, 01:08 AM
pl4yboy

Quote:

Originally Posted by sprayedenali

eagle doesnt make pistons...?

I was thinking crank. Weisco makes pistons.
11-15-2010, 10:33 PM
Slammed96

Ill def be lookin into all of them...hopefully I can get this thing done with at least a semblance of a budget
thanks again for the help