+05 e-fans, nelson harness, 4l80e trans, hughes 4l80e converter, np263 transfer case

2003 GM Chevy 4L80E Transmission 2WD. 75K miles, worked fine when removed.

Asking $699 plus shipping

http://i37.photobucket.com/albums/e5...y/DSC02533.jpg

-------------------------------------

2005+ E-fans and nelson harness both new in box

Nelson harness ** sold**

***Fans SOLD***
http://i37.photobucket.com/albums/e5...y/DSC02639.jpg

----------------------------------

----------------------------------

Hughes 4L80E 3000 RPM stall converter with lockup.
Bought for a project but never used...fresh from Hughes has dual bolt pattern.
***SOLD***
http://www.summitracing.com/parts/HUP-25-30L/
----------------------------------

NP263 HD Transfercase and front driveshaft from 2005 Chevy truck with 18K miles.
Bought a pullout drivetrain for a swap and don't need the t-case.
***SOLD***
--------------------------------------

Clean parts. What did the Fans originally come off of? I have a 03' Slivy with the 5.3 just want to make sure they would fit my Radiator. Interested

The fans are brand new, not sure if they were factory take offs or if they were ordered from gm. They should fit any 99-06 truck with the larger radiator that measures 34" between end tanks (radiator core width).

like a week too late or i'd have the fans and harness gone for ya... just put my fans and made myself a harness a week ago....

BUMP for good stuff!

damn good deal for the tranny and verter. If someone buys my FLT65E Ill buy that tranny and verter

I measured out my Radiator and its 28" core size. I don't think it will work unless someone else comments that I can use it. Bump for seller if not.

Quote:

---

Originally Posted by polos954rr

I measured out my Radiator and its 28" core size. I don't think it will work unless someone else comments that I can use it. Bump for seller if not.

---

You need to either buy the large radiator or get a set of ls1 fans off an f-body.

Is the trans slip yolk or bolt in yolk?

IS the nelson harness the kind for a 1 pcm pin setup or setup to run both pins to the pcm?

I believe it's setup for one pin to the pcm and one to an a/c trigger.