- 
	
	
	
		Tow/Haul button question 
		Its never been answered (atleast from what I've found on the net)... but has anyone wired up a BCM to get the tow/haul workikng? 
 The BCM's require programming from the facotry so if you had to program this thing could you through the OBD socket to our conversions? There is a write up on this same question on hptuners, but its for a LS1 computer and its different than our truck computers.
 So if anyones gotten this feature to work, chime in.
 clint
 
 
- 
	
	
	
	
		All you need is a momentary switch and wire it up.  Mount the switch wherever you want it. 
 
- 
	
	
	
	
		Could you give connector and pin numbers? From the research I've done it's a momentary ground going to the BCM and the BCM sends a message to the PCM over the Class2 bus