New leather seats

So i bought a set of seats out of a 02 and up silverado about i am putting them in my 99 silverado, how hard is this going to be, the scrap yard i got them out of cut the crap out of the wires how much work is re wiring going to be. thanks for the help.

Here are a few pictures of the seats. one of the frames ended up being bent in half so it took a little longer to get that fixed. I wish i had pictures of the repair job. it is a piece of aluminum shower curtin rail, flattened at one end with a hole drilled in it, at the other end is a duct tape hose clamp and sheet metal support so the seat wont collapse. words dont do it justice.


http://www.ls1truck.com/upload/files/473/SDC10474.JPG

http://www.ls1truck.com/upload/files/473/SDC10478.JPG

i am still learning how to post pictures so they are not urls. i read the directions but i am not a computer person.

bolts right in, just hook up positive and ground for power seats... dummy proof if ya ask me

thanks man. do i need a special socket to get the bolts out. or will a standard socket work.

it should bolt right up or some slight modifications... some guy put gto seats on his NNBS . . w/out any problem

thank you. i hope they fit

It is best to use the special socket but I have used a 12 point SAE(not metric) socket in the past and it worked fine.

+1 :thumb:

where can i get one of those.

Dealer, or just got to Autozone or some where that sells handtools to do the job bro..

screw that, get a 15mm for the fron bolts and i think a 13mm for the rear bolts, comes right out!