I need to get the 12v + pin in my 7 pin RV plug powered up. How do I do this?
Printable View
I need to get the 12v + pin in my 7 pin RV plug powered up. How do I do this?
run a fused/ignition wire from the front to the back. gary
Is that the charge wire? If the truck has towing package it already has the wire it just needs pulled from the tape holding it to the underhood harness and attached to the stud on the fuse panel. Also need to pull the red "dummy fuse" from the panel and put the fuse that comes taped to the loose factory brake controller harness in the slot where the dummy was. If it does not have the towing package you have to do all of the above plus run the wire.
It has the factory tow package. I'm gonna try to get it hooked up this weekend.
thanks