Cam Tools?

Printable View

08-16-2009, 11:15 PM
WARLOCK

Cam Tools?

Anyone have the JPR cam install tool? or The valve spring tools?
08-17-2009, 08:24 PM
jetmech

Quote:

Originally Posted by WARLOCK

Anyone have the JPR cam install tool? or The valve spring tools?

I have a crane cams valve spring compressor
08-17-2009, 08:47 PM
WARLOCK

Willing to rent it when the time comes?
08-17-2009, 08:56 PM
GasGuzzler

Who's got the pass it around tool? I know Mark had it and shipped it elsewhere but then what?
08-17-2009, 09:16 PM
WARLOCK

I was wondering that myself. What you you use at the dealership to keep the lifters up?
08-17-2009, 10:12 PM
jetmech

Sure, I'll rent it out whenever. I used it once and I've been trying to sell it ever since. Works great though
08-17-2009, 10:14 PM
WARLOCK

Pm sent
08-17-2009, 10:21 PM
blue0453

to hold the lifters up just go to advance or autozone and buy a 48" piece of 5/16 steel brake line cut to 21" pieces out of it. thats what I did and it worked great and only cost like 10 bucks
08-17-2009, 10:23 PM
WARLOCK

Ive heard of dowel rods too. I take it there are just 2 holes in the block for the tools to go into? IVe never done a cam swap on one of these..
08-17-2009, 10:36 PM
blue0453

Quote:

Originally Posted by WARLOCK

Ive heard of dowel rods too. I take it there are just 2 holes in the block for the tools to go into? IVe never done a cam swap on one of these..

yeah just lube the rods and they slide right in to hold lifters up

All times are GMT -5. The time now is 05:34 PM.