New Budget Build for the Test Truck. :)

Since I sold the old stuff prior to getting to have any real fun with it, and the truck been sitting for awhile; desided to build a little bit stronger engine. but keep it as a budget build.

Picked up a set of L92's, 6.0L, some new rods, Pistons. The bottom end is being build as strong as a stock iron block can handle. LSX just out of price range.

The Heads are getting a little port work to them not much just cleaning up the guide area and enlarging the exhaust ports some. Final compression will be below 9 to 1. NOt sure yet, final decking and head clean up cuts are not finalize yet. The truck should be a nice street truck once done. Gots lots to do still. Finish the intake, get the tranny, list is just really long right now. LOL

Hope to have something running in a few months. :) Might even get to go to the next shoot out.:hyper2:

Intake
http://www.trickperformanceproducts....0_3322_jpg.jpg

pistons
http://www.trickperformanceproducts....piston_jpg.jpg
http://www.trickperformanceproducts....iston2_jpg.jpg

http://www.trickperformanceproducts....6_0rod_jpg.jpg

http://www.trickperformanceproducts...._head2_jpg.jpg

http://www.trickperformanceproducts....0_head_jpg.jpg

Dude the intake looks great! :lol:

Yea, everyone keeps mentioning that. LOL

What made you decide to go with L92 heads?

The heads flow over 300 out of the box, and this is a buget build. :) These heads cost me just over 400 including the shipping and I think are really really nice heads for the coin.

nice are you doin boost or spray

WE are going either large single or large twins w/nitrous not sure just yet. Have lots of things to work out.
The bottle will help the spool time with either set up. :)

Looks like we are going twins. :) either 70's or 76's. Been kicking around the new look new set up for a couple of months now. So far twins are the parts.:). Pass side is 75% done, driverside is 30% done.
Now hopefully I do not change my mind again. LOL

Block is machined and threaded for some new head studs. Stock stud is on the right.
http://www.trickperformanceproducts....0studs_jpg.jpg

You should lay down some good numbers with twin 76's. You have any pics of the progress so far?