Dyno tuned my truck finally!

Yesterday I was up at Lethal, Heres sme vids. Truck made 389rwhp and 357ft/lbs of torque. I would of liked to have seen 400 but I knw my lifters and pushrods need to be swapped. Not too bad for an automatic with a 3400 stall:)

YouTube - Seans LS1 Truck Dyno 4

YouTube - Seans LS1 Truck Dyno 2

YouTube - Seans LS1 Truck Dyno 3

Looks Good.

Nioce!

You gotta come back up to Austin so I can do a rolling second gear burn with it out if front of "ol boys" house again :naughty:

Quote:

---

Originally Posted by ATX ENGINE MAN

You gotta come back up to Austin so I can do a rolling second gear burn with it out if front of "ol boys" house again :naughty:

---

:LOL::LOL::LOL: No way man!!! You lost Sean truck priviledges!!! Maniac!

Looks real good! I hope to be in the 400 range as well after some heads.

very impressive, nice pulls and sweet numbers, personally the lifters would be fine, now on the other hand if the push rods arent harden then yeah i would get them changed!!!

Thanks! Yea these lifters are shot, chattering like crazy. They are stock, as well as the pushrods, smething I shoulda changed when I put the heads and cam on but didnt think I needed to right away:(

We milled the heads about.030. Those lifters are pretty close to the bottom of the hydraulic travel. The right length push rods will pick up a few numbers.