I need help.........will they tuck????

See here, I dont wanna retype the whole thing again....

Will they tuck?? – MiniTruckinWeb.com Wheels & Tires Forum

you will have to measure the offset. here is how

Lay the wheel face up, put something straight across the wheel. yardstick, 2X4, some thing . Then grab your tape measure and measure from the center hub to the thing laying across the wheel.take that measurement from the hub on your truck and place a straight edge from the inner finder to the ground and that will tell you where the wheel is gonna set. Tires with a 20 go with a 275/45/20 or maybe a 40 series

Do what murdered_outgmc says but I'd take a wheel off, install the new one and run a straight edge across the wheel to the top of the fenderwell. This way you could see how much room you have from the wheel to the fender.

Yeah nitrous is right. Lets us see some pics of the wheels.

Ill see if I cant get some pics up for you. The new wheels are already on the truck and the stick out a little but I cant tell if they will tuck if I get some lower profile tires for them. The offset is currently 5.5 from what I understand.

These were taken with the camera phone so they arent the best but you get the idea..........

http://i73.photobucket.com/albums/i2...0125091915.jpg

http://i73.photobucket.com/albums/i2...0125091916.jpg

http://i73.photobucket.com/albums/i2...0125091914.jpg

those look like they won't tuck. Especially in the rear.

the rear looks like it would tuck easier than the front. I think they might tuck with lower profile tires, the ones on there now stick out a little from the lip of the rim.